Видео

Lost my clutch and stuck in gear in bush I broke front brake hose off and belt came off now both clutch and brake pedals are soft ,silly question but is the brake reservoir connected to clutch I can't move it

How do I fill the fluid for the hydraulic clutch? I'm getting the cylinder replaced but need to fill the fluid to make it until my appt

Ive been having no crank no start issues with my jk. Someone said it is more than likely the clutch interlock switch that needs replacing. I had the battery alternator and startor tested and all passed. I thought it may be the TIPM, but a texas shop said no. Any of you guys had this issue? Typically i have to wait and itll start back up again.

10 mechanics where asked what was the worst vehicle purchase nine out of 10 said jeep

Been looking for a video to do this damn thing. I’m replacing the brake booster but of course manual has this dumb cylinder.

Thanks for this vid. Every time I have work on this stupid thing I watch the first 10 seconds of this and I instantly feel better knowing I'm not alone out there. 😂

When I pulled the hydraulic line out of the old slave, there was no little rubber cap. I did it slow are carefully and I'm certain it didn't fly off and roll away. I looked inside and even smashed the slave open with a hammer and it wasn't there. The boot was torn on the old one though. I inserted the line into the new slave, removed the master cylinder cap and pumped it by hand until it had pressure. Then I bolted it up and pressed the clutch about 50 times. Jeep was parked facing up hill. I then put the cap back on and drove it around the block. It works perfectly fine. I checked the slave and no leaks. My question to anybody and everybody is, has anyone experienced this also? Not having the little rubber cap? I haven't driven it far yet so if it starts leaking I know why. But so far so good and it's interesting that there was no cap present. 🤷‍♂️ Does anyone know the part number for the hydraulic line? Just incase.

You save my life men. Tanks

awesome post, thank you

Thanks very much for posting! This was super helpful.

Still no RUclips video for it (least for a JK)...'til yours! Thanks man 👌🏽 How long did it take you overall, n what did you struggle the most on?

Lost the clutch pedal in my 13 JKUR 8 months ago and it was the slave cylinder. Just lost it again today and the slave looks fine so I’m guessing it’s my master, but it’s not leaking. I definitely have no pedal though... damned Jeeps. You’re right though... this is the only JK clutch master cylinder video on RUclips.

💪👏🏻

Gtfo no way they actually made that it’s like car companies don’t know how to make cars

Thank you

Thank you! What cables did you use? Do you have part number by chance or the link which one to buy?

This has to be the worst car repair video ever

First Jeep, purchase pre-owned, Rubicon, stupid clutch squeaks and feels like it binds.. replacing this, as i can't figure out what the hell else it could be, shifts fine, but that binding feeling when it's hot, sucks ass.. Rather do the work that even under warranty deal with the dealerships.

Thanks!! Great help.

I have 2017 hyundai elantra manual trans. can't even replaced my shift knob because of that click when you reverse.

Fucking perfect. Finally, I find this video. Jeeps leak making me replace the master cylinder and possibly the tube, but I was weary to attempt without a little guidance. Appreciate you man

Good video. I used a different platform (Verizon Connect) and they have the same adapter. Easier to remove the front panel instead of fishing for the power supply. Please make sure to use the DL1 not the DL3 labeled resistor as this will miss data. This is for the side you are connecting the resistors.

Thanks for the vid! I think what broke on mine was the connector where the pedal hooks up to the master cylinder plunger. It still needed to be replaced.

My seals failed on mine today while in traffic, so I couldn't let it stop. Luckly I was able to get it into a couple gears with a little southern charm🤫. The signals🚦were in my favor, so she it home safely - thank God. Ordered another clutch master. Still wouldn't give up on my JK, but she does nickle and dime me🤪. Whatta Father's Day. Thanks for the video😁👍🇺🇸. OlllllllO

lol dont ever buy one, you will be wrenching for life!

This works for a 2016 Hyundai Elantra too. Thanks!

how do you replace an 2014 Hyundai sonata shifter knob?

Thank you so much, I pryed and poked at this shifter for a half an hour.

Thanks a lot bro 😂

Haha! I bet I'll smack myself in the nose! Thanks!!

Hell yea thank you

Thanks man saved my ss

Good job! Thank you I was searching everywhere trying to figure this out!

God bless u lol

You need to make more videos, cuz I like your videos they are straight to the point

The best part is the beginning when Mike says its not going to work with one winch.