Видео

Actually, I leave them public so potential customers can see that I've worked on a few switches.

@@RG_Rax_YT all of them

One more for now

@@twoseventhree what would you suggest instead? I’m trying to make it be smoother and will eventually be running an ESP32 instead. I did lower the delay and it was able to be smoother but I know it could be better

@@huntercustom9970 const int ledPins[] = {9, 10, 11}; // LED pins const int buttonPin = 2; enum State { NORMAL, SEQUENTIAL }; State currentState = NORMAL; bool buttonPressed = false; unsigned long previousMillis = 0; const long interval = 1000; // 1 second interval for LED change int currentLed = 0; void setup() { for (int i = 0; i < 3; i++) { pinMode(ledPins[i], OUTPUT); } pinMode(buttonPin, INPUT_PULLUP); // Use internal pull-up resistor // Set all LEDs to red initially for (int i = 0; i < 3; i++) { digitalWrite(ledPins[i], HIGH); } } void loop() { unsigned long currentMillis = millis(); // Check for button press if (digitalRead(buttonPin) == LOW && !buttonPressed) { buttonPressed = true; currentState = SEQUENTIAL; currentLed = 0; previousMillis = currentMillis; // Reset the timing for the sequential state } // State machine switch (currentState) { case NORMAL: // In normal state, all LEDs are red (already set in setup) break; case SEQUENTIAL: // In sequential state, LEDs light up in sequence if (currentMillis - previousMillis >= interval) { previousMillis = currentMillis; // Turn off all LEDs for (int i = 0; i < 3; i++) { digitalWrite(ledPins[i], LOW); } // Turn on the current LED in orange (assuming we use the same LEDs) digitalWrite(ledPins[currentLed], HIGH); currentLed = (currentLed + 1) % 3; // Move to the next LED } break; } // Reset button press flag after a short debounce period if (buttonPressed && currentMillis - previousMillis >= 50) { buttonPressed = false; } }

@@RG_Rax_YT some custom DRLs for my car that I’m working on

same haha

I can't even tell you that one

should be up. HunterCustom.net or huntercustom.etsy.com

best potato around

where is the dudes address? all you've got is his name

A total of $75 and I’m located in the US out of Andover Ct

Hi excuse me, after install hwfly to a switch lite, and appear de logo no sd card, what are the next steps?