Видео

Plate I swapped out the silicone plate dampener with PE but you could stack them ontop of each other (when cutting the PE foam make sure to leave room for the magnetic sensor) 2 layers of masking tape then 2 layers of duct tape Switches: Lubed Case dampening Filled the bottom of the case with coins Kept stock foam Lined the entire bottom with duct tape If you try to put it back into the case it shouldnt fit all the way down and thats fine Just screw it in enough so that it doesnt lift above the plate but just enough for it to go down a bit. Stabilizers: Balanced the wire Holee modded ruclips.net/video/GHkv3VdQbKs/видео.htmlsi=ajSjv_nZ2D5mApkl

I heard if u open the keyboard it well mess with the software

@ it works perfectly fine for me, theres more battery wire that would end up messing with the software for this board. As long as you’re careful with handling the board you’re good to go. In reference ive opened the board 7+ times by now to try to make it sound better. And it still works perfectly fine

@@GreySolstice alr

very much so

on god bro