Видео

@@calloftheoutdoors8941 the super Duper has some amazing action in the water on its own, so you don’t really need to do anything other than crank real real slow. When I’m working the super Duper, my main thought is just keeping it off the bottom, or keep it from touching the bottom.

@@Jetmech1085 you don’t need paperwork on the troll motor unless your installing a titled gas motor on one of the larger kayaks. Then they’re going to require a title on that motor. But on trolling motors, the good thing is that you can swap troll motors without any legal issues. FYI, I will be selling my new 10 foot green Kayak and My 12 foot blue kayak. Going to be working on a 12 foot Nucanu.

@@ahmondeboxley2950 sorry to hear that you had such bad experience. I had to try lots of different manufacturers, sizes and styles until I finally found a pellet that worked.

@@thescottishhammer7570 you know I couldn’t tell you, but I did start over by the spillway and the headquarters. I got about halfway down the seep before I stopped.

@@Doug-rp5ik Congratulations! I’m sure you’re very proud of your property just like I am. Many people asked me where to buy property and I tell them…..find it and buy it, because it’s not getting any cheaper.

@@garzaoutdoorsproductions Good advice. I bought three different ranches, I’m sure glad I bought them when I did.

@@dodge73dart I released two additional videos, one how to remove a stuck pedal and the other one how to correct a backwards, turning propeller. I guess I mentally checked the direction every time I replace a belt. Thanks for the comment.

@@garzaoutdoorsproductions My comment about the direction was for the benefit of those who may have never done one before and didn’t realize there were two ways to orient the belt around the lower shaft drive.

@@Cruzgarza-u1j I can probably come up with an adapter for that one. Also let your friends know that I’m going to be selling the green kayak (featured in this video) and the blue kayak (that’s in all the other videos). The blue one has sonar on it. I will be keeping the new sonar that’s on the green one, but will probably leave the adapter for the next person. Send me your information at Garzaoutdoors247@gmail.com

@@garzaoutdoorsproductions sure will I’ll let my friend know about your kayak thank you very much

@@CrazyQuadBrothersP3 the water was definitely calm in that spot because the wind was coming over that dam and over that rock ledge, but on the main lake, the wind was blowing about 10 miles an hour. Crossing an open lake with 10 mile an hour wind in a small kayak is not without its risks. The skiers were about half a mile away, and I was still feeling the effects of their huge waves where I was fishing.

@@tuckerschultz6876 Usually I look on Google and see where I can find a decent place to park so I can fish those creeks. That particular one is next to a church, but I don’t remember which church. Also, the great part about that Creek is the second time I went there. The grass was low so I could handle my fly line better. I usually try to find a creek that has plenty of open area behind me for the back cast. I’ll be up there this weekend. Maybe I can find out what that church name is. Hopefully also they’re still cutting the grass. I don’t know if you noticed, but they were cutting the grass while I was fishing and that threw a lot of junk in the water that made it unfishable, so I had to cut the video short.

Ya beat me by 13 minutes! Lol

@@msb2948 I saw wild black bass in the stream while I was trout fishing. I think they were well educated because they weren’t going after the flies that I was using for rainbow trout. I heard they regularly stock, black bass channel cat, and of course rainbow trout. One thing for sure the water is extremely cold so the trout live longer into the spring.

@@Cruzgarza-u1j what model Magellan are you using?

@@Cruzgarza-u1j send me an email at garzaoutdoors247@gmail.com

Remember, you’re gonna be putting in a parking lot because there is no Boat Ramp right now. The boat ramp is still 10 foot underwater.

Thanks for sharing. Now I have a trolling motor on mine. May head out there soon

@@TheREVIEWGUY1-ip1wm my son is stationed at McConnell Air Force Base in Wichita Kansas, so I had that opportunity to go there once I dropped off my wife to help with the grandkids. I don’t get a chance to go there too often because it’s out of my way. But I’ll keep that in mind next time I swing by there. Thanks for the information. Tight line.

@@mg181 This error occurs when you pull the belt down to the lower unit and instead of twisted it clockwise they twisted it counterclockwise(or vice versa) and that’s what causes the petals to work in reverse. Repairing it is quite simple. 1- loosen the tension screw 2-Pull the prop off pull the three screws that hold the lower unit cover and then slowly remove the prop shaft. The easiest way to do this is to move the pedals back-and-forth (just the wiggle) as you pull the prop shaft out. 3- Have a screwdriver handy because you’ll need to insert the screwdriver to keep the belt from going up into the unit. Without moving the pedals, remove the screwdriver, and let the belt, relax. Observe which direction it turns. 4- Then very carefully twist the belt in the direction it was turning on its own. If you turn it in the wrong direction, the belt will get shorter. That’s not what you want to do so twisted in the other direction. 5- Now remove the screwdriver at the same time insert the prop shaft. Your target is the bearing in the back with the prop shaft. To achieve this move the pedals going back-and-forth. Remember, this is just a wiggle, not a complete rotation on the pedals. 6- Slowly insert the prop shaft until it reaches the bearing in the back. 7- Now replace the cover, the three screws, your prop pin/sheer pin, and propeller and you should be good to go. Good luck.

@garzaoutdoorsproductions you wouldn't want to make a video of that would you? Please! Ha...

@@mg181 i’ll take my camera to a service call Thursday and video just that process, but it may take some time before I edit it and upload it. Where are you located?

Massachusetts ​@@garzaoutdoorsproductions

@@mg181 yep, too far for a service call. I don’t have a pedal drive because I sold mine and went with the troll motor as you can see in my fishing videos.

tpwd.texas.gov/?_ga=2.37805414.473609412.1654401792-1870178321.1654401792

tpwd.texas.gov/?_ga=2.37805414.473609412.1654401792-1870178321.1654401792

I now use a pulley puller. put the screw about 1/4 back in and then use the puller to pull it off.

@@garzaoutdoorsproductions I’ll let you know how that goes haha

@@garzaoutdoorsproductions you should totally make a video on how you did it hahah, I broke my puller

@@jackybonbong OK that sounds like a project. I have done at least 40 or 50 pedal drives using the puller method.

@@jackybonbong I just put out a video showing how to remove a stuck pedal. I hope that helps.

Still have the blue kayak, although I’m using a green camouflage kayak now, with a little more advanced electronics. (Side scan)

They are called Joe’s short strike. I got these at Cabela’s. You can also get them on Amazon. When you get them, take off the spinner and just use them as a regular fly. The reason they are called Joe’s short strike is because they have a piece of braided line with a treble hook on the end of a regular hook. Good luck keep me informed.

Heavier JSB’s seem to be the best on the Benjamin discovery. Although it seems (from all the comments) that the Benjamin prefers the heavier, Slugs, I have not had a chance to buy heavier Slugs to try them out. If I do, I will post a video.

Wow, 3-D printed. How is the accuracy? On paper I mean.

I built that style of stand 40 years ago. I was younger and limber back then. The door use to open easier but let yellow jackets in. This new deer stand is tight but the door is harder to open. I have been planning stairs with a landing. Just need to save some money.

Glad you liked it. We actually lost the video on the pig shot. The cable disconnected from the scope, and the file was not closed. I was excited to get it out there on RUclips, that I double typed a word and didn’t catch it till I was reviewing the footage. I could’ve corrected it, but then I would lose all the views. Thanks for your comment. Good Hunting and good fishing out there.

Hello It’s ready to go. Unfortunately I have not had the chance to go hunting with it. Good news. We are getting a surge pig at the ranch. The Bulldog may see some action. I will post it if I am successful.

Did you paint a kayak or a storage container?

@@garzaoutdoorsproductions I painted my vertical storage container

D&D PowerDrive 1295-5M-15 Timing Belt, Rubber a.co/d/ftefoIK

Try this site www.lsonews.com/annual-rainbow-trout-stocking-begins-nov-23/

Absolutamente. El único rifle que hizo mejor era el Benjamen bulldog. 357 Yo no he tenido el tiempo ni el dinero para comprar otro tamaño de diablitos para calar en los mismos rifles.

I hope you subscribe to the channel so you can see when I release the next video of the Sandbass in the marinas. This happens every year and sometimes they just move in an out earlier, depending on the water temperature. The Shad run also has a lot to do with the timing.

Depending on the time of year, they will bust the surface more often. Typically Buffalo and carp will bust the surface early in the morning. It could be real annoying when you think they’re surfacing Croppie or Sand Bass, and it turns out to be just carp. Maybe you should try breaking out some doughballs and at least get your line stretched. It can be kind of a relaxing way of fishing.

I asked myself that same question. So I did the research and found out that it would actually work better on a 223 barrel without doing the 22 barrel conversion. The problem that you run into is that the 22 magnum has a lot more power requiring a lot stiffer spring. In other words, more weight on the bolt , and to my knowledge no they do not have a conversion yet, although I have seen some 17 HMR that people were toying around with.