Видео

Thanks for the Detail on getting seals in.

Thanks for the help Rodney 👍

Thanks brother! I'll be doing my 99 F250 in a few days.

great vid Rodney !. I have been through this process at least 10 times with my 04. My calipers use phenolic pistons. I found out that over time the plastic swells and sticks the pistons in the bore- or makes them very hard ( takes 150 lbs air to blow them out) that caused the brakes to drag and fail to release. The little square rubber O-Ring is the ONLY thing that pulls the piston backwards when your foot comes off the brake. That little O-Ring cant exert much force- so its very important that the pistons move free- as you said - 20 PSI. Another big problem is that rebuilt calipers all most always have the guide pins bent. (prob the ears bent where they screw in) You have to very slightly grind the seating face and get the pins parallel so the other half doesnt cock sideways and bite into the pin and lock the whole thing up. Rodney--- do you know if the earlier calipers with the steel pistons will fit on the 99 -04 trucks ? Those plastic pistons are just trash. The earlier steel ones are slightly smaller. But will the earlier caliper mate with the later chassis. ( I am SRW 2004) Tim

You are the man Rodney. Thank you

I thank you and your wife Mr Rodney. Just bought me an RV and the brakes are sticking. I removed the calipers in under a minute and then I was lie...What do I do from here?.. and the good Lord lead me to you sir! God Bless you!

Your demo and words built my confidence to rebuild mine for $10 rather than replace for $80. Wish me luck!

Rodney nice video but would be nice if you listed part no. Where you got it. Thx

Thank you Rodney got a kit on the way for tomorrow thank you very much

You do help me solve my problem, many people put the seal in the opposite way, it really confused me a lot! By the way, why you didn’t put the iron ring after the seal is on?

Good video!

Great video! Exactly what I needed. Where did you get the snazzy stainless pistons?

Can you share the part numbers for the pistons and seals?

He’ll yeah Rodney! Good on ya brother! Gonna rebuild my stick 2001 superduty caliper this weekend instead of buying another one. Again!

Thank you this is what I needed your awesome

Thanks Rodney. Very to the point. Excellent job.

Thank you so much for the information ,Really nice video .your right nobody has shown it for f350 trucks

Like ur video got to do same with mine

Looking foward to see brake caliper with metal ring on it which you could show more info on the dust boot facing which direction to install like toyota brake calipers

Thanks Rodney👍 I'm a marine tech shop owner down here in Florida. If you ever down in Palm Beach give me a shout. My business is A1A Advanced Marine. I'll take ya out deep sea fishing 🎣 keep the videos coming. Good, well detailed videos are hard to come by!

Thanks man! That's just the info I needed.