Видео

Pour bypass de la sonde de 4 fils?

Bhae kaha hai ap ki workshop

Consulta a un carri con caja cuarta se le puede colocar caja quinta en q le afecta

Topo vídeo

Masha allah Good ❤

Sir i have Hyundai accent 2013 mode i remove the oxygen sensor connector but there is no check light in dashboard meter why this not showing on dishbord meter please,?

لا عمو ما اريد اصير فيه ترى بطلت

السلام عليكم شلونك عمو عمو اريد اتعلم فيتا ابوي عنده اغراض مال فيتر اسرع سيارات ابدل ماكينات اشكال والماء تتعلم من عندك😊

👍👍👍

I would like to ask question to understand about hit sensors? show 2.7.dis is ok or mast be different numbers of sensor ? And I have bank 1sensor voltage 3.266 to understand where do I have to connect dis resistor? If you can give me eany information about please 🙏 thanks Eand I have bank 1 equivalence ratio is 0.996 .to understand where is mast be connect dıs resistens ? Thanks 🙏👍

I have the same problem with my 2006 daihatsu sirion. The o/d off light is blinking and there is an acceleration problem. Today I took it to the official service. They cleaned the solenoids, changed the transmission oil and transmission filter. But I still have the same problem 😢

Sir my car is some time shift ev mode 30secend only ev mode

Imran sb m kal ap k pass aa raha hon, tuning m code wala faida dena hai... Talagang chakwal sy

Cannot hear you or understand you

It’s give me po606 ecu code what should I do

My Vezel 2014 very rare converting on EV mode what could be the reason. No caution lights appearing. Can anyone guide.

سلام بھائی کیا مجھے اپ کا نمبر مل سکتا ہے تھوڑی رہنمائی کے لیے شکریہ

Agar new gari ko zang lgna shroo ho jae to usko ya coating kr sktae hain kia?? Iski resale price ma farq to nahin parae ga

Hi, can I use this method for my van? My van is showing engine light and it is saying sensor is not good.

I have different error code on my prius 2012 C2311 Can you help me?

You are the best

All i saw was a ball scratching session that went without accident

Kaha hota hai ye map sensor

This is verry halpfull to me menny thanks to you keep them vidios going kind regards to you

Seems honest

Mashallah g

my brother you are life saver. my right fender broke and my ground harness was exposed I thought it was going to be a problem with water/rain so I unbolt it and hid the harness after starting car and driving all those lights and check engine light came up. seen your video screwed the ground harness back and car was good agine. thank you!!

At 4 min 10 seconds you comment that we will need to have a 1 OHM resister then you install a 500 OHM resister ??????? in the heater line ?????????

HI I need your help on my Toyota Vitz, code U 0100 and U 0129.

Very good video ...when you d0 this bypass do you ever get a heater code for high circuit on heater when your heatwr circuit is good

can I do both just to get rid the check engine after catalytic converter delete?

Hi, You used, 1Momhs 1/4 w and the 1uf 5 V or 50v.

would this work for a p0137(low voltage from rear o2)? the sensor is the correct one and good but since i installed headers its been setting it as a nuisance code

Is fan ke pride kya ba

Assalam o Alaikum Bro. Bro mry ps bhi Glory 580 Pro hai, mry sth ek problem rhti hai jb bhi high speed pr jata hn to Traction control light on hojati hai, kya apky sath esa hota hai??

2005 Jeep Wrangler 4.0 all 4 sensors testing low on heater code P0031 - P0037-p0051-p0057 I replaced all with NGK and still lit on. I checked all the wires, disconnected the PCM, and continuity was all good, Pin 1-3-4 were good from the sensor to PCM plug and pin 2 to ground, what else?? Thank youi

Can we replaced pistons sleeves in 1kz engine?

bhai daraz sy tcs ksy kry

Aoa bhai y kis shop sy milti hy

Remot connect Kesy krty hain 10 video dekh li bus speed ka batate hain on aapka batate Hain kam kaise karte hain tej kaise karte hain yah kaise karte hain filhal kaise karte hain Koi remote ko connect Karne ka tarika Nahin bata raha start me connect kaise krty hain

Bravo - you outsmart the sensor, the control unit recognizes it as OK. It just can't regulate it, your ECU always gets the same input. As a result, the car never runs properly. BUT - you will no longer receive an error message!! Your crafting is total nonsense!

Sir hamara order aya hai bluex per mandi bahaudin se or unho ne fraud kiya hai hum wapis kaise karain parcel please bata dain

Actually heater wires don't make sound when you test it by multimeter and 2 wires have the resistance between 3-10 ohm.

Bhai I have same issue, but I have power and ground on abs module harness

1 ohm is to small

La resistencia puede ser ser de 1M ohm 1/2 watt, y el capacitor de 1uf 50v segun entiendo (no se porque pero en unos paises cambia el color de la resistencia 😢)

The blue color is a signal rite & white is a eart?

thanks for the video, helpful

How did u solve the propblem?

Solar pa concert kasa krta ha ya b btao 🤬