Видео

It was printing intermittent lines after the manual cleaning process, and using the printer driver through the computer, the problem was solved. Welcome.

It leaves a mark on the side of the paper during printing. After examining the fuser, conveyor belt, drum set, and transit roller, it was found that the transfer roller was damaged on the right side, causing it to leave a mark on the paper. Thank you يترك اثر على جانب الورقة أثناء الطباعة بعد فحص الفوزر والحزام الناقل ومجموعة الدرم ورولة الترانزيت تبين ان رولة الترانس فير متضررة من طرف اليمين م...

Separating the flex tape, cleaning it well from the socket, and putting it back again solved the problem, thank you

Frameware updated tas calfa 3010i

Hello everyone: The problem may be the fuser belt rotation sensor or the flange rotation motor, which is located next to the printer

The printer was not working at all. We repaired the power supply and the problem was solved

The printer came and said it was not pulling paper from the paper tray, but after inspection it was found that the paper tray elevator gears were broken and were replaced.

During the printing process, the printer slows down, its rotation becomes heavy, and it gives us an error code C2000. We cleaned the gear assembly and the problem was solved.

It was leaving a black line along the length of the i4 paper. We found a damaged upper roller, as shown at the beginning of the video, then we changed it and the problem was solved.

Today we have the error code: paper jam: 0000, but we did not find any jammed paper at all. Rather, we found the paper exit sensor was crooked. We adjusted it and the problem was solved. Have a nice day

disk.yandex.com.tr/d/Qiz1gcwm3UECwf After entering Reset Mode through the printer, you begin the process of resetting the printer through the program

The printer was suffering from a malfunction in the Wi-Fi, which prompted us to extract the IP address and write it manually in the Setap program, and the process of connecting the Wi-Fi printer to the computer took place.

When a CDF 0 error message appears, all Toshiba instructions refer to the rear motor responsible for the rotation of the toner shaft or the motor that makes the gears rotate, and this has nothing to do with this error at all. All it has to do is that it is sensitive to the output rollers of the paper, which is always open, which leads to the appearance of the above error message. Solution: Clos...

Periodic Service When the consumption counter of the internal parts of the printer ends, this warning message appears. Do not worry, you can reset these counters as shown in the video above, and the printer will return to its normal state and be fully ready to work efficiently. Thank you.

xerox 3160 Red light flashing.

Epson L382 printer head cleaning

reset time periodic maintenance toshiba e-Studio 356,256,357,355,455

toshiba e-Studio 356se ADF Photocopy Blurred Fix

Epson G3010/G3110/G3210/G3510/G3810/G3910 installation and connection on the computer

Epson L3060 Withdraw the ink from the printer tank and clean the printer head

Xerox C8055 High Voltage Card Repair

Repair Color mixing Epson L3060.

Canon MF8280CW cartridge error repair.

Save your money repairing the Kyocera M5521CDN Transfer cleaning unit.

Samsung M2020 power supply repair.

all Epson ink pad reset.

Repair fuser toshiba 365se and replacement thermostat.

Repair Black color in Epson L3150.

Repair Pepper Jam Samsung SCX4521F