Видео

Hi, it's not problem but my configuration correct for X and Y 200 steps and Z, E 400 steps Nema motors, step of Z screw 2 mm do you have the same?

:o thanks for answer!! :D ok mine is very bad :( this are my actual settings: #define DEFAULT_AXIS_STEPS_PER_UNIT {157.4804,157.4804,600.0*8/3,190*1.1} // default steps per unit for Ultimaker #define DEFAULT_MAX_FEEDRATE {500, 500, 5, 25} // (mm/sec) #define DEFAULT_MAX_ACCELERATION {9000,9000,100,10000} // X, Y, Z, E maximum start speed for accelerated moves. E default values are good for Skeinforge 40+, for older versions raise them a lot. #define DEFAULT_ACCELERATION 3000 // X, Y, Z and E max acceleration in mm/s^2 for printing moves #define DEFAULT_RETRACT_ACCELERATION 3000 // X, Y, Z and E max acceleration in mm/s^2 for retracts what accelerations do you have? :D

give me your mail, I will send my settings

Igor T. A lot of thanks!!!!! ryutakuzaki@gmail.com

Can you sendme this settings too. No works steps Z. weeberp@outlook.com

а кто что-то писал про Рентгены? разве не видно по переключателям - частичек на см2 за минуту