Видео

Change your pump to pull off the lower line. Return at the top. Cold water sinks it will mix your tank more efficiently and lessen spot boiling

Greetings from Finland. Your name sounds Finnish 👍

Very good ❤❤❤❤❤

Can you put the snow blower on the front loader

I inherited a CB 6048 with the resort I bought. It is now around 22 years old. It’s been a good stove, we heat 7500 sq ft . I added the duel fuel but the amount I have let it kick in I quickly realized I’m not rich enough to run it on propane ! Lol . I burn 20+ cords a season in northern Ontario. During the -35 we just had I filled it every 6 hrs to keep the 3 cabins and residence worm. And I must add that my dealer is Andrew @H&H and has been awesome to deal with.

Always good to have some fun when it’s cold outside 🙂

Wow that is cold, we moan when it gets below zero. I am pleased you have got the truck sorted. The hot water trick looked funn

How's she goin'? Wow, when you say it's cold out you don't fool around!! Glad to hear you got your truck fixed up. It's nice when a company handles your issues to your satisfaction. Take care and stay warm!!

Getting a little chilly out there! Good to see you out and about. Glad to hear the warranty came good on the repairs. Stinks that a known issue isn't something that a factory recall would cover. They just don't build em like they use to. Looking forward to seeing more content from you. Keep on tractoring!

Jack frost nibbling at your nose?

Forgot about Dave's challenge. 😂 Might have to try it one night. -1°F here now. Have a good week Mark and Stay safe and warm. ❄🧊

Truly OUTSTANDING Video Mon Ami Cheers 🍻🍻

That Is Pretty Cold -50c !!! 🥶🥶🤣🤣👍👍

We Just lost 5th and 6th gear on our 2020 Ram diesel. What broke on the your transmission?

urs is nice but the 7260 the door is at the ground so u can rool the big logs in easy on ur back and walk inside of her great unit

I had one, it burned 22 cords of hard wood. It was wired wrong, had a local person look at it, zero customer service, called them for three months. I used it two winters then during the following summer, I gave it away. Then bought a Heatmore, burned 7 cord of wood. Excellent customer service. Used this one for six years and sold it. Heat with propane now.

🧐👌👍🍻

It is great that you have a good outcome to the problem. It is always a good day with you get great customer service

If the damper is closed and you want to open the door, don’t just pull it open but unlatch it (keep hand on lever against roller bearings) and wait 10-20 seconds for the smoke to go up the chimney, THEN pull it open. -You can have a back draft if it recently had cycled off and you open it by pulling it open too fast. -that’s a memorable event. Enjoy the furnace. I have had a dual fuel ready 5648 at least 20 years, heating 2 houses. I only burn wood.

Good Evening Sir Mike 👌😇👍 Very Nice Service That You Have Received Mon Ami 🧐👍👍Keep Warm Cheers 🍻🍻

Good stuff. The way it should be. Fix it and back in business.

You should definitely have the engine block heater plugged in for at least half hour. What a huge difference it makes, much better for the engine. Aaron from Cape Breton

Love seeing smiles while making lumber!!! Subscribed

I have the same one bought in 07, I had to lower the Water temp 165/175 for the Domestic as it over heated the Safety on the Water heater Gas valve . I had 4 zone Base Board Hydronic so no mixing needed. I did install a mixing valve for domestic 140 Deg water out the tap was a bit much. My whole System was home brewed and worked very well till 2019 When the house was replaced and I moved out taking the OWB with Me, Since My new place has in-slab Heat I lowered the temp even more 145/155 I do not need mixing valves at all And since the whole system is no-pressurised I do not need Heat separation Cept for the Domestic. My flat plate for the Domestic is close to the floor to get the most out of thermocycling and do not need to run a Pump to get it going. i remove the Drain from the bottom of the Water heater tank a plumbe the whole Ckit with 3/4" parts including a Filter rated for Hot water. The Filter keeps any Crud from getting in the Flat Plate. I wired the Front Light to the Damper Ckt with a blue C7 Bulb That lets Me know when the Damper was open I also had one in the house too.. With a Rifle scope I could see the Temp on the Love controller HAHAHAHAH Can not see it at My new place. It is so nice walking in bare feet on a warm floor HAHAHAHAH.... One thing I did at My new place is raise up the OWB 1+ Cinder blocks high So I did not have to lean over to put Wood in. being 6"4+ It was a face full of Smoke now it is so much nicer.

That should do it.

How's she goin'? Happy New Year!!

Happy New Year. Those heaters are sure handy

Be safe

Happy New Year! Your have problems that we would not even consider. The heater is a good solution

I hope you are having a great holiday

Hi Mari Merry Christmas You guys, nice to see Mark today, wished it was under better circumstances.

👌🧐👍Happy that Mark Is Doing Better Cheers 🍻

Nice job on the excavator. That's the way to get it done.

Great job. All I have for this winter is some green Ash. Man, I am having trouble getting it to burn! LOL

Hope ya had a good Christmas. Happy New Year as well.

Happy New Year folks!

The excavator is a great tool for processing these logs. Great team work

Nice job!

You made a great choice I absolutely love mine

How's she goin'? Neat tip about insulating the ground before you start but with temps like your had, no wonder it didn't thaw it completely eh!! A cold job, but you did it!! Nice to see you getting around again Mark!! Merry Christmas!! Take 'er easy!!

SO COLD!!

Digging in the winter does not look easy in your part of the world. For us the challenge this time of year is the mud and getting equipment stuck. Great job getting it done

Stay warm Merry Christmas 🌲

Not easy this time of year. First time I've seen that thawing process. Ya gotter done.

Looking good! We'll done. Keep warm. Interesting about the insulation test. Glad to see you are hobbling around nicely. A cab is probably a good idea on most equipment 😊 Merry Christmas to you and your family!

Got one just like it in 2006 only not the titanium model. Mine is now in it's 19th season and I have a forced air blower burning wood only.

What a great review & information. Thanks 😊

Forks tilting down is what caused the issue.

Yes that’s a big blower for sure. Whoops! Looks pretty tough but rough way to test it. Thanks for sharing Cheers, Mike