Видео

Using Autodesk Fusion's fastener feature: - remove old fasteners, tidy up surfaces - place a fastener stack.

Basic sweeps in Autodesk Fusion.

Using Autodesk Fusion to modify a pulley inside of an assembly: - section view and history - splitting bodies - moving - using extrudes unexpectedly - joining

One (thorough?) approach to fully-constrained 3d sketches in Autodesk Fusion.

A 3d line. That's it. - coordinate versus polar versus both in Autodesk Fusion.

Autodesk Fusion

Using fusion to modify a STEP assembly as per Orlov's Fundamentals of Machine Design, fig 2.46(a-e). Rule: reducing centring diameter. archive.org/details/orlov_MachineDesign_2/page/80/mode/2up

Using Autodesk Fusion to correct a taper-mounted shaft. As per Orlov, fig: 2.153. Tightening of tapered joints. archive.org/details/orlov_MachineDesign_2/page/184/mode/2up

Previously, we added some clearance holes - so what's the new volume?

Hmm: standardized clearance holes?

Using Autodesk Fusion to moel a adjustabe clip. Sometimes surfaces can save a lot of effort in the middle of a standard modelling effort.

Using Autodesk Fusion to place fasteners in two ways: - Placing from McMaster-Carr. - Using the fastener feature.

Autodesk Fusion: - simplification in two ways - meshing - simulation - re-design - results and interpretations.

Using a No2x50 bit in Autodesk Fusion.

Autodesk Fusion meshing intro

prdt320 2025: inspecting an S2 50mm

prdt320 2025: modelling an S2 50mm

mech200 2024: razor holder, hatching, again, long

mech200 2024: shoe, construction

mech200 2024: shoe, shaping

mech200 2024: fish shape, construction

mech200 2024: fish shape, hatching

mech200 2024: razor holder, hatching

mech200 2024: razor holder, construction

Fusion for Solidworks users

mech200 2024: drive shaft, construction

mech200 2024: drive shaft, hatching

prdt310 2024: stand

mech200 2024: bracket 2, hatching