Видео

those kholers don’t like cold at all, but they still start, a little carb cleaner doesn’t hurt

On top of the mountain Pretty cool

looks so much better with the lifted front bumper. you are doing a lot, waiting for more to see how it turns out...

I have an old 1985 murray lawn and garden tractor. Same type rims. The way you changed the rims is correct. Someone had the rims bolted on backwards!

Nice

* find*

Where is the first barn fine

More of this please. Could watch you start that thing every day!

jealous, I wannanother 4X4 S-10...

No muffler? 😂😂

Mine has a 10hp tecumseh pretty sure rod began knocking today

Can you do a tutorial

Did you put any bushings or bearings in the wheel?

Lucky dog. I busted the case on my peerless 820 and can't find another transaxle.

what engine it has. ?

What exactly did you put on the hood?

Takes 4 minutes to take off deck and about 10 to put on.

Kohlers that I've used are cold blooded. One was on a Terramite. Anything much below 50 it was a challenge to get started. Sounded just like this one.

This is not how to test a fan clutch. Worked fine here, with a very loose clutch, but if its a good clutch, fan blades can get damaged. I've seen a metal blade come off a running fan, because it was damaged, and out balance.

Thanks for sharing!

Awesome coverage!

2:35 damn that right wheel went hard right .. to the ground great video

This is EXACTLY what I came to YT to see! Thanks for this!

What is the “one of these” you refer to in your video?

thanks for the straightforward demonstration.

DID YOU BACK INTO THE CAMERA?

TRY MOVING YOUR SEAT BACK SOME AND YOU WILL GET BETTER TRACTION.

There a good tractor! What are you trying to do with the dirt you keep driving over?

What happens if I find the cars but they won't load in my yard like I click on them they said they're getting sent to the yard but they're not there

Actually that was lucky to get a mixed bag of rods when trying out the welder, lets you know how it'll run on those too and which rod to buy next😊

Heat Quench it

You could definitely fit more man

ALL OF IT👌

Bro I use my crv to haul scrap all thw time. I can fit 2 full sized washers in the back 😊

Thanks 😂

I already got the barracuda so if I build it can I find thr Camaro or s

Y

I have an old Craftsman I use for the same kinda stuff. I built a floating mount for the front so i can push cars up on the lift with it.

Looks like a lot of fun. When I had the deck off of the Kubota diesel I couldn't resist popping a few wheelies as well.

Who da fook is dis guy?

Boy, whoever built that little hydro did a great job.......😁

you almost had it

Where's part 2?

Still using your video for repair of this antique generator for my husband. His recoil starter needs replaced and ran across this video searching for a replacement recoil. Nice Save!!

Hell ya

Hopefully insurance pays for it

Verry sad 🥺😭

Lol y'all wild

Whew, I wouldn't let go of the Peerless 2500 series if installed on any of those. I finally got a Ford LGT17.5H, which is a Gilson design, so have a basis to begin with modifying the YT's to have the beefier rear end. I'll most likely be welding pipe or more steel on the chassis to begin with. Will be interesting to see how to fit other implements as well to be as interchangeable as I can be with what I have for the farm boys.

Awesome footage! Loving the wheelies, Youd think id be okay with being out in the back yard talking to myself on camera by now but im not 😅 so i feel you lol