Видео

VF8 bung nhưng VF7 thì ko b. Người ngồi VF7 cũng bị chấn thương nhẹ.

Ngu vcc hahaa

The bracket that comes with the lever does not have a hole to hold the mirror. I have to order a custom bracket from a CNC workshop.

I bought them separately.

No doubt about it. Thanks for your comment. Best wishes to you.

There are total 3 screws and 2 filters. 3 screws: (video 5:16) ~ They are all come with the gaskets. So, I recommend you replace the gasket or reuse it only one time. The smallest one: 18~22Nm. I decided 20Nm The next one (under the oil pan): 22~28Nm. I decided 27Nm The last one( on the side oil pan): 38~46Nm. I decided 43Nm 2 Oil filter: The bigger(replaced with new one) : 10~12Nm The plastic one (video 14:35): Unknow but hand tightening is enough, don't do it too hard.

Muchas gracias

We don’t need to drain the oil. When the engine stops, almost the oil are flown down to the oil can.

Theo cảm nhận của mình thì sau khi chạy 1000km, thay nhớt thì bớt nóng hơn. Hiện tại mình chạy 6 tới 6.5L/100km.

@@vothuat dạ. Em đọc trên web nói tầm 5L. Vây là em ko lẻ loi rồi. Ha ha.

@@HieuYaourt 5L chắc chạy xuống dốc đó b. Mình thử đủ cách r, không bao h xuống tới 5L đc đâu.

@@vothuat dạ. Anh ở đâu anh. Chắc có dịp mong được gặp gỡ anh chỉ giáo với so sánh thử đời mới có nâng cấp gi hơn đời cũ ko. Hehe

From the motorbike workshop.

That is the Hex 6mm. However, you can find the full instructions to install it (size and torque) on the Ducabike website. link: ducabike.com/ducatiparts/en/diavel-my-11/174-ppa01-water-pump-protection.html

Jesus! After a few months, I still didn't realize that thing. Thanks for your notice. Have a nice time with your 1100s.🤣🤣

lol, i was about to comment the same thing 🤣🤣🤣

There are 3 hex nuts with size: 5mm,12mm and 14mm For the mesh filter (plastic filter) you can use the Spark Plug Opener (Smaller end) in the toolkit to remove it.

Hi, I would like to keep all the oem part so I can not sell it to you. Sorry about that. Have a nice day.

My flashers don't have that problem. I think you have picked the wrong part code. The guy from AMS Ducati Support helped me to find the right part code for my bike. My bike is Monster 821 2019, and the right part code of the Ducati performance flasher is SKU 96680201A (the front and rear are the same).

I did not install the relay. All you need is the right part code for your bike, then plug-and-play. The relay is already on the light.

Thanks. Glad that you like the video.

@@vothuat Your bike looks very clean.

@@keltecdan Thanks. Actually, The bike is more than 3 years old and I had just washed it before making this clip.

Hi, I am in Vietnam. Some of the parts were ordered directly from ducabike website, some I ordered from vendors in the US.

The original tail used only hex bolts. Actually, the Torx bolts that I can find on my bike are in the brake rotors (brake disc) of the front wheels.

For the 2018 model and later, you only need the Led lights. The front, and rear use the same part code, everything is plug-and-play. For the 2015 model, the front and the rear are different. The rear may similar to the one on this clip, the front needs another type of connector because the light is installed on the side of the headlight. You can check this link: amsducati.com/ducati-led-turn-signals . Actually, I was confused with too much part code of the light. So, I sent the email to AMS Ducati and asked them for the specific part code for my bike model.

After 3 years and 16000 km, so far so good. The feeling of the drive-by-wire is a little bit delayed when you twist <6 degrees on the grip. However, the time will solve it when you are familiar with the bike.

That sounds good. Hello from Vietnam!!!!

It depends on the type of the brake switch (Always close or always open). I am not sure which is the type of M821 but the switch that comes with the Brembo RCS works well on my bike.

Thanks, I believe that the stock brake and clutch Master Cylinder on 1200 is the radial type already. So, the RCS or Corsa will fit. You will not need any adapter. Happy New Year!!

@@vothuat its fits the bike more (1 piece ) and yes ai was thinking also for the rcs , stock ones are ughly ( cafe racer has the ducati factory brake master cylinder looks great on the bike ) but instead ducati puts a cheap master on it , why ????

Được nhé b.

Mình tự đặt trên web rồi nhờ người gửi về bạn.

Mình tự đặt gửi về bạn.

Hi, sorry for not using English. My native language is Vietnamese. But, If you have any issues, I can help you If I could!

Sory, I have forgotten the configuration.

Luckily I can find the link to configuration sheet. I believe this link will help you. My configuration is on line 122. docs.google.com/spreadsheets/d/1O74-AtgwDmYoWErgZocGJnhkJ8qgFJRrvQI3IYQctDk/edit?pli=1&pli=1#gid=0 Enjoy.

Cảm ơn bác. Mình cũng đang tập từ từ. Tập từ dắt xe đến chạy xe. Chỉ lúc giờ nào đường vắng mới dám lấy ra chạy.:-D

@@vothuat lỡ ghiền thì đành chịu khó bác :))

docs.google.com/spreadsheets/d/1O74-AtgwDmYoWErgZocGJnhkJ8qgFJRrvQI3IYQctDk/edit?pli=1&pli=1#gid=0 Dòng 122 nhé bạn

Can you use English?

Mr Big no, goole translate !

Its ok im find naza geyns config for this copter

+Stalker Pofi can you use English? I do not understand Russian.

Sorry. I am going to collect the same model (Robocat + naza lite). For this purpose I chose : ESC - Littlebee 20A BLHelli, motors - 2300KV. Do you think it is suitable ? I have very little information , agree to help me set up my model ?

That model is fine. Of course, I can help you.

+vothuat Thank you. The fact that I once collected a . All of the default settings . The first time she flew into the sky vertically , management did not react . Now I am looking forward to new details .

+vothuat What did I do wrong? Installed ESC emax 12A BLheli, motors DYS 2400KV, propellers 5030 , Flight Controller naza-m lite. ESC before installing calibrated its equipment Radiolink at9. I have made all the settings assistant. Configured in the apparatus of flight modes , and f / s. Before the flight calibrated GPS. It may be necessary to fine tune the control equipment . Gas , gain, is still something ?