Видео

karma

Thanks for the compliment. Mine was fairly well lubricated with some type of grease in the problem area. Most of the remaining noise came from the big roller that the belt rides on at the other end. It was quiet enough for my purposes. A lubricant that isn't prone to thickening up when it captures fine dust would be necessary. Maybe some dri-slide?

Thank you for clearing that up. I was at a loss.

Good catch. I hadn't really noticed that until you pointed it out. There could be limitations due to the screw placements but, most likely it had enough clearance to work and I did not think past that and left it un-centered.

@@everlitesv yea, not a big deal but stuff like that tends to bother me. I saw as you were doing it that the screw for letting the belt body be moved upright was tight. Maybe later, when you want to bother with it, make sure that screw is loose before trying to adjust the housing. I just bought a ne hf bauer sander and I was happily surprised that I found very little wrong with it. As I read the instructions, I do this with everything I get, I noticed it had a knob to help adjust the belt so no prying needed. Good luck.

On Thingiverse Thing:2796202 3018 CNC Engraving / Milling Machine Accessory Set by 8SquareFeet February 16, 2018. There are links above in the show more. that should now work. They were broken until I just fixed them.

If you are comfortable assembling the machine and have the space, yes I would.

I agree. Nice tip. Most of the two sided tape has a wiggle factor. I'm now mostly using mechanical fastening. I purchased the ca glue and accelerator to try that method a while back but haven't used it yet. Thanks.

I really like it. It would be nice to have the space for something a tad larger sometimes though. I have a friend with a sign shop and I have access to their copy of Vectric Aspire. But that 2d cut could be made in most cnc software. That sign took about 2.5-3 hours runtime. I've learned how to optimize toolpaths a tad more now and could probably get it down to 2 or less.

Yes, It's something I'll try with my next projects. Eventually I'll install a touch probe.

I tried this method and it doesn't work reliably. There is something about the Dewalt collet that on about the last turn to tighten the bit, it draws up into the router about 0.5 mm or so.

@@solderandsawdust Thank you for testing this and reporting back :).

This happens with most collets, even on the industrial machines I work on at work. The tool draws into the collet ever so slightly. Probe or piece of paper is a common practice in the industry.