Видео

This guy is a fucking moron, no info or explanation. Just terrible angle and no clues

-Use Trim-panel-tool to pry up rear sides of console bezel panel (Clipped in place) -Start engine, put into neutral, set emergency brake, turn off engine -Pull down shifter bezel, remove wire clip from shift knob and set aside, pull off shift-knob -Slide bezel panel out, and set aside. -Remove wires if necessary, by pushing in on side of harness clips . . .

I'm looking at replacing the USB port in my 2018 Murano and figure this might be the easiest way to get to it. So did you just pry the armrest off? No screws holding it down?

But why

Camera angle is poor, you are in the way for the viewer to see what you are doing!

What was purpose removing audio/ navigation, did you exchange with new unit android auto / car play ??

How much would something like that cost to replace

Great video

What’s that little orange tool you’re using to take the first piece off

Where do you located

*WHY THE FUCK* would you post a video where the initial step is blocked from view? Don't understand why people go thru the trouble of posting, but then, in essence, make the entire video useless by doing shit like this.

Some parts of this video are helpful and some are not. Even if you don't like your voice on video you should give some input to let us know what's going on. Thanks for a little bit of help.

Man your not showing the first part.. thats where km stuck you cant see what your doing

straight to the point