Видео

mas apakah bisa pesan yang buat motong sudut sama yang dorongan motong lurus itu?

Cách làm rất tuyệt vời

Your mommy just teach you how to use a screw gun or how to install latches that are older than you?

video about driving screws?

Nice

Kreatif sekali mas

Atasnya di beri kaca anti peluru saya rasa itu ide yg bagus dan aman , jika kayu terlempar tidak masalah saya rasa ini terobosan yg bagus semoga nanti ada yg membuat 🙂

Keren mas

el taller de San Joae, fue una muestra del hermoso oficio, recuerdo al maestro en la secndaria, yo no hacia nada y nunca me reprobo, algo de esa moral debo haber apicado, ceo, calficaba examenes mas por la actitu al estudio que por las opcione contestadas, el policia adjunto

Merk nya ap gan..?

You know, that can be the next best thing. A tape measure with an integrated pen/pencil holder to make your marks.

Apakah bisa utk band saw 8"?

Very nice, thanks for this!!

Simple y efectivo. Gracias!

Bentuk gunungn ada gak om

The screech! Lubricate that slide, please.

I have similar offset, but I didn't manage to do a perfect 90 with that, so I did a sled for it 😊

Do you have plans???

I like this a lot. I was looking for a good way to slide open a small box without a drawer. This gives me many ideas.

Went from cutting past the line to being right on the line. The magic of editing

Salam pade .. Itu mata gergaji ukuran brpa

Coustomize kora possible?

Pp

🙏👍👍👍

Thank you Sir.🎉

Dont sand on the upward half, you're going to have a bad time.

Sorry, I read that you wanted to make a video for the table saw jig but I cannot find it. Have you done it, at the end? Thank you!

Beautiful wood work

Assalamualaikum.. pake pernis apa om? 1 lapis sja?

One man’s innovations are another man’s poor

Isnt that sunk too low now? Would have been better to be flush.

Ijin bang.. kalau bisa di buat tutorial perawatan mesin tabel saw juga, paling tidak cara memberi minyak pelumas di mesin tabel saw..trima kasih 🙏🙏🙏

Salam dari bandung

Sangat presisi pa de ...

Mantab om,lanjutkan👍

Nibbling - like a termite.

После пропила вставляйте клинышек,не будет схлопываться.

Kayu apa bang itu ?

Cepat dibubut gan

Berapa harga nya om ? Saya punya band saw 8 inc

Hadir ikut menyimak dan belajar om

om pake dowel atau cuma lem aja?

Bs pesan tebal 3mm

awesome job

Bro, you make me nervous watching how close you’re willing to get to that blade. Recipie for a missing finger

Nice job making pushing the board safer just to reach over a running table saw to grab that same board.

Mantab, kayunya apa itu mas, putih tapi keras ..kayak Oak

cara membuat gunungan dan lingkaran belum ada videonya apa mas? thanks

Bos macam mana mau dapat ini mata blade ...mesin saya 9 inci

😳 "PromoSM"