Видео

Also do check sleep mode n hibernate mode too, brother .. good job

beautiful mashlla

street cat best

Bhi number to hide kar lata

Wahhh jalan2 naik pesawatt seeuu kk

Not working

Thank you 😊❤

Straight to the point. I love it. Just got sc & tryna figure it out before diving in. Thank you 😊

Like video show nhi ho raha h kya kare

Thank you 👍

He is ped@

Thank uh so muchh 🙏🏻

You should tell what it is and how it works. We didn't understand anything

ruclips.net/user/shortsGo2wPw64Y2A?si=kc3e2kGAPRoTWF90

How to off the saving option of snaps in chat in Snapchat

thankyou so much

Thanks for the number

Tq❤

does the wattage changes when you use the laptop on full capacity? for example you are gaming. on what the video shown, the laptop is on idle and consumes around 20watts. I want to know if this will change if you use it on full load. hope you can try this. thank you

what was your screen brighness level at around? and what is yur laptop model?

Thankyou so much

Can anybody tell me how much watt it consumed ??

can I get a link to your filament tension knob? (upper left)

Thankyou very much, now i can estimate how much the electricity cost in my rent house business. Can you make another video when the laptop charging at 0%? and what laptop do you use?

helloo i'm from thingiverse!!

✨🔥🤘🏽

It’s on idle that it uses 18 watts…

Is that to high?

If you convert from 30fps to 60fps via software, final result is only increasing video size without increase video quality. We still hope there is update firmware that make possible to setting video record at 60fps

explain idiot..u expect everyone to know?

OMG 🥺 Poor fly , but to be very honest camera result is mind blowing

If im not mistaken, the charger does not consume electricity when it is not connected to laptop charger port?

masha allah

Mashallah

You don't show the end result, neither you share the STL file, what is the purpose of this video? Also, this could have been a 10 second video

Nobody cares LULZ

Left one is still far from a good print. Why not directly set up the printer correctly? Extruder calibration, PID autotuning, correctly assemble the hotend (it comes assembled very badly)...and then start printing.

Very good this one is much better then previous on ... good job 👍

No supports for the clip part ? (left object, the one that does a bridge) :)

You can never beat the skill of Pakistani pilots. Always providing a super smooth landing