Видео

Not necessarily, we do have Allstar nodes that are on a Multimode network and brings, dstar , dmr , ysf , Echolink & Peanut to the same node. However it's down to the individual subscriber who Bridge from us how they gate that connection . But we do have rf gateway's

Yes it's 2G ram and 128g on TF card & it's 4G

These radios any good or is it best to stick to inrico mate

@garyhull7037 To be honest, I haven't been playing on the side yet

@ruhaidinklate4658 i can receive 70cm fm amateur radio band, it can tx but I haven't tried that yet. However, it's not like a real transiver

@rts3262 I thought the air band reception was reasonable, but I am 3 miles from the airport 🛫 de Mark 2E1CEQ

@@Ham-Radio-3.0 I live less than a half mile from the local airport. At first I thought I might be off frequency a litttle, but no. I think I just have a faulty radio.

No spam bot

Hello I don't understand the question ??

Yep , why did Yeasu not do this? I honestly don't know

Morning Unfortunately not, All networks available to us radio ham's require the subscriber to hold an amateur radio callsign & licence. Mark 2E1CEQ

@beedsleepmusic SEO if you don't mind me asking

@@Ham-Radio-3.0 seo mean ( search engine optimization)

@@Ham-Radio-3.0 SEO will grow your channel faster

@@Ham-Radio-3.0 check f,,b

@beedsleepmusic Ok thank you

Thank you Chris Would be great if I can get into VK3 mobile with my G90

@@Ham-Radio-3.0 its possible try on 20m about 9am or 9pm thats my mobile vk magic times

@@vk3xemontheweb Absolutely Simon de Mark 2E1CEQ

@@vk3xemontheweb And we have BLF enabled without problems

It was a hard decision to walk away from BLF on HH. The reason has to do with CPU load on the servers with over 10,000 connected endpoints, it really adds up. Our primary goal is reliability, and not flashy lights. We are now simply dropping BLF subscribe packets at the firewall instead of banning.

​@mrwizworks that's good to know , thank you for the post and update Mark 2E1CEQ

@vk3xemontheweb please stop bashing HH on youtubes. The team at HH is very dedicated to the project, and they had to make some hard decisions for the benefit of the success of the project. Some of the "differences" you have highlighted on this, and other youtubes that you troll were due to some folks not following the standard procedures on the technical side of things. The project stewards and leadership did their best to attempt to resolve differences, but at the end of the day chose to do what is best for the project, instead of allowing some folks to further their egos. They also had to restore 3 servers that were "tapped" with unauthorized software/monitoring that was installed by one of the engineers who was asked to leave. THat engineer (without naming names) was one of the people who were already trying to gut HH and start Hams Over IP. If you ask me, that's pretty grimey.

Search the Big Kansas Coil, watch out for postage and import duty if you are in the uk. You can ask questions, send Ryan a message

@@Ham-Radio-3.0 I did a Google on it and got a list that looks like it is available in the USA (directly). I haven't had time to review the search yet but after my morning coffee I'm sure it will be best to take it on. I'm an apartment dweller and need all the simple tricks to get the most out of a small simple antenna. Thanks for the help.

@James-hy8gu Thank you . Please have a look at my other videos

@2e0hpi The band was open to Europe, but unfortunately, due to time constraints and mom coming home no contacts

@2e0hpi Had a brief chat to I.O.M with a 2D0

Strange video presentation. Why the flashing circle and borders?

@landytravels9427 I find if I record from the screen I can show a lot more. However, I do have a downside

@prisim Hello Sorry didn't include a direct link to the blog. Plesse find the link below wiki.moobug.net/amateur_radio/sip_services/?fbclid=IwZXh0bgNhZW0CMTEAAR27Qb_lBERlp6ttESQ1dDYXc5E_fbsp9yG44N5ebrnvOE9bNHkATIM76mc_aem_qmvVsl4xuocWE0U4yyV7zQ

@prisim Hi Have you managed to read that blog, if you need me to send a link via email. Please reach out via QRZ 🙏 mark 2E1CEQ

Haven't really done anything with your blog , bit of a test video with a new app.

Thank you Ryan, it's in the country and due to be delivered on Friday

Yes I know but my choice , let's look at the quality once I receive the coil

Hello I do believe that was stated in the instructions, it's two hot to play in the shack . I will read them again later lol thank you for watching 73 de mark 2E1CEQ

Thank you , it's not just about the cost , it's about enjoying the hobby

@@Ham-Radio-3.0 Of course and thanks for sharing the video Mark. Always good to see new gear. Can't wait to see a follow up on how it performs for you. I've the G90 too ;)

Hi You're welcome Anything else you need please don't hesitate to ask. de Mark 2E1CEQ

Thank you

Hi Pretty much is done on the phone config web interface, on the keypad itself I use . Once I open a line on HamsOverip I press *97 and press dial, for voicemail. DND do not disturb is set on the phone itself (separate button) *99 to ptt then # to stop talking

*99 to PTT then # to stop talking only in Allstar Bridge extensions . Full duplex in conference room and one to one calls so ptt isn't required

Hi I have a list of DTMF keyboard codes. Please find me on facebook or via qrx . I will be have to share Mark 2E1CEQ

Yes, location Bournemouth UK , hope to catch you on HF while I'm out mobile/portable 73 de Mark 2E1CEQ

That's great 👍

Hello What happens when you press the menu button, the one below the envelope button ? Can you plug it in to your router and search for the ip address with an ip scanner on your cellphone. If you can put the ip address into your browser on your PC and tell me what you see.

Any update ?

Thanks for reply. The screen never turns on even when pressing the menu button. I haven't checked with an IP scanner yet. I'll put a video up on it. I appreciate your help. Thanks!

Unfortunately it could be a failed phone. Check to see if you can send it back

And to you Carl thank you so much

Your welcome m8

Hi I've always had the W2 and I don't use dvswitch on it yet. My favourite modes if peanut .

Something I could look into

That's an interesting idea

The whole setup was very clean and easy . The 22amp battery 🔋 was so light I've carried heavy shopping.

Thank you

Don't forget to watch my other video's. Thank you

Hi I can be fun 😁

Morning I will see you on C4FM de Mark 2E1CEQ

Thank you Search my channel. I have other videos on another Voip phone my cisco spa525g2

Good morning

I don't understand your post

Morning Don't look at the device , it's just a phone. But when connected to our ham radio pbx asterisk network , its ham radio. You can dial into the freestar network on 2196 & 2167 allstar node, an international Allstar node network . With a number of repeaters, gateway's, and even on 29mhz fm . Now that's amateur radio

You're welcome 73 de Mark 2E1CEQ Admin Team Member HamsOverIP

That's the phone book on our website

Don't forget our discord chat server , everybody hangs around on discord

Hello Please use our help desk site and not the website , which is causing us some issues. I will post the link to our help desk ticket site , but you would have to create a new account, and then you can proceed to create an extension ticket

helpdesk.hamsoverip.com/osticket/

Hello How did you get on

Hello We have members of HoIP who are members of HH and can work side by side . We have config info on the 525g but unfortunately I have little experience with the 7960 . However no doubt someone on our discord group can help . Mark 2E1CEQ Admin Team Member HamsOverIP

Hello again We have your extension request 🎟 I will leave it open just incase someone can process that. If not I will do that once I get home later