Видео

install corresponding driver and connect the relay with your laptop .change the com port and make device online ,below click connected device you get read all file

thanks for your valueble comments ,in the output matrix kindly assign the particular contacts and also we have to set each contacts latching or un latching but protection functions are always unlatched

@@switchon7938 can I get your WhatsApp to discuss with you?

@@switchon7938 yes I assigned the BO for each function but when the function is active the BO not energise still open??!!!

​@@Mqasim0313increase BO making time

@@switchon7938 What about hand rest function, output pulse function? Making None or choice BO

Thank you so much 🙏

First save the file and near to that save icon you have send option

@@switchon7938 we are creating this project file in offline without connecting the relay. if we want to extract the existing project file & make change in that & send back to relay then how to do pl tell.

1.use reydisp evolution software connect the relay with serial port 2.in thesoftware page left side down you found connected device 3.just click it ,once it connected then click the download settings 4.after download ,configure it after complete your configuration click save and click update setting then send the file by clicking upward arrow icon on the top of your page . @@sirajpasha4618

For that you have to change the name in input and output matrix

@@switchon7938 where pl tell

SURE MY DEAR FRIEND

its output command from scada to reset 86 and all led's

You have to assign a single point output command spdoes to bo9 which I am not shown in this video

Sir how to make this setting in pdf or cxcel export option

Fir printing