Видео

Thank you sir.

Thank you so much ! This worked on my Mazda this is very much appreciated!

Thank you. This worked for my 2013 Mazda 6.

Mr. Patel, Please post your transcript in English as well. Thank you.

This worked! Thank you!

Thank for your sharing. I tried to short as your i struction today but the aux mode still keeping in off mode. If there any other solution？Thank you very much.

Must watch for the blinking purple light on the opener or procedure won't work.

If I can give you 1 million likes, I would!

The keypad for the openers eats a set of batteries every 3 weeks ant idea of the issue. I have 95+ deg heat for the entire summer.

This is gold!!! The keypad doesn’t tell you to reset to monitor

Light never goes out or stops blinking on first step for me

First

Worked on the first try!!! Thank you!

If you press the learn button for a few second it will clear the code and the other remote for the garage door wont work , then you need to program all all of them again . Only the key pad will work. I think just quick press on the learn key will do.

You made programming door easy. Thank you

Thanks for your information yesterday I watched your video and today I do it you are correct . Best Regards

Sanjay, thanks so much! I have a 7055d. The manual's instructions do not work. You saved me time and probably some money.

only vid that works

Thank you so much 🙏🏾

My memory card is different, Sanyo green card with 5 pins in a row, and 5 distributed around the left hand side. Which ones do I need to short please? Only numbers are 1-5? Thanks

Thank you Sanjay. You are a lifesaver. After four years, l can finally use the keypad to open my garage door 😂.

A hardy THANK YOU!

Tamaru name su chhe ?

Hello

Thanks you helped a lot

good video

Thank u Sanjay for ur advice 😊

So many dumb instruction booklet and online video. This is simple and works. Thanks 🙏

Thanks for your video. How many remotes can I program to my Genie opener? I have 4.

I would give this video 15,000 thumbs up if I could.

Perfect!!! Thank you!

Great video! After a week of trying to program it, calls to Genie (went unanswered) this video got it done.

Thank you! Worked great!

This is the best instruction so far on the internet... Thank you so much Mr. Patel

Worked perfectly. Thanks so much for sharing

Thank you so much for the video. It worked for me. Keep up the good work.

Very well done. Thank you!!!!

Bro thank you this is like trying to decode the Dead Sea scrolls thank you!!!

THANK YOU!! The instructions do not say to hit the up/down three times. Once I did that, boom. It worked. Thank you again.

First time go. Thank you for the help.

Thank you 🙏🏻

Set code, go to page 9, Enter 357, start at step 1, go to page 9… loop de loop de loop… F that! Go to RUclips University and learn the world!

You’ve been an awesome help! Thank you!!

Thank you !

How do you program the wall button without numbers

Very helpful. Thank you Sanjaybhai 🙏🏻

Ty worked perfect

Man that was the best video there! Thank you!!

Thank you This helped me figure it out

Thank you so much; the guy that installed my opener left me hanging without doing the keypad. Couldn't have done it without your video!!!