![GARAGE POINT ZERO](/img/default-banner.jpg)
- Видео 57
- Просмотров 91 887
GARAGE POINT ZERO
Добавлен 3 дек 2012
Stuff i like to do or build.
ENCORE Rog 12RKSS water heater
I ADDED A BOX TO MY ROG CAMPER
BOX
nanuk.com/products/nanuk-990?_pos=3&_sid=741d6c885&_ss=r
BOX
nanuk.com/products/nanuk-990?_pos=3&_sid=741d6c885&_ss=r
Просмотров: 139
Видео
ENCORE ROG PROJECTS
Просмотров 16121 день назад
These are some little projects I have done on my 12rkss rog solar, soft start, propane quick connect. quick connect amzn.to/3Axoyvd blocks amzn.to/3Axoyvd solar panel amzn.to/4dNTSnH solar charger amzn.to/4cAAERN
Gladiator bed power/water tank
Просмотров 411Месяц назад
This was me getting power to the bed also the water tank
harbor freight barn hoist
Просмотров 93Месяц назад
I put a hoist up in the barn for rtt removal Strut Menards ® SKU: 3656566 L bracket Menards ® SKU: 3656737 4 Wheel Light Duty Trolley Assembly amzn.to/3Y6qiVT 2Wheel Trolley Assembly amzn.to/3zF7d2W Channel Trolley Track Hanger amzn.to/3Y6v59Z
encore rog 12rk walk around
Просмотров 3903 месяца назад
This is a little video about how we set up our rog for camping.
SETTING UP THE ROG 12RK
Просмотров 1223 месяца назад
WE SET UP THE AWNING AND THE SHOWER TENT FOR THE FIRST TIME
DBBB with tristate overland
Просмотров 4544 месяца назад
I meet them last year at the same ride kft (Kentucky fried trails) at the DBBB. This is day 1 there will be a day 2 next week. we stayed at Callies campground. Tristate overland is Ohio Pennsylvania West Virginia and I thought it was our tristate Ohio Kentucky Indiana but I had a good time so I went again.
Hydro dip the jeep gladiator dashboard
Просмотров 4634 месяца назад
I did not like the red dashboard. hydro dip amzn.to/3Ufudxs activator amzn.to/4cR4tPn
Rog Eclipse
Просмотров 684 месяца назад
Encore Rog 12RKdoing the eclipse First trip with the new camper. We went camping at Brookville lake Indiana for the eclipse and I thought was a stupid reason to take PTO from work but I have to admit it was really cool seeing with my friends and family. Totality at 1:05
jeep gladiator bed rails and the trailer MUST SEE!!
Просмотров 1845 месяцев назад
I used some unistrut from Lowes to make bed rails for the cap. We also pulled a trailer
jeep gladiator Redarc Brake controller
Просмотров 5055 месяцев назад
I installed a the Redarc brake controller on the gladiator. brake controller www.redarcelectronics.com/us/tow-pro-elite-electric-brake-controller wire www.redarcelectronics.com/us/jeep-gladiator-wrangler-suitable-tow-pro-brake-controller-harness-tph-022
Gladiator Barricade Adventure HD Front Bumper
Просмотров 1755 месяцев назад
I installed a front bumper on my Jeep Gladiator Barricade Adventure HD Front Bumper www.extremeterrain.com/barricade-jeep-gladiator-adventure-hd-front-bumper-jg1184.html
What to do to jeep / Shawnee state park
Просмотров 3065 месяцев назад
more about what i am going to do to the jeep but also some Shwanee state park stuff
OOO NOOO what did I do to my F150
Просмотров 4386 месяцев назад
We took most of the stuff out of the F150 and moving it to the ??????
Maxx air dome fan install f150 overlanding
Просмотров 2,9 тыс.Год назад
Maxx air dome fan install f150 overlanding
LAND BETWEEN THE LAKES & Hotel California
Просмотров 271Год назад
LAND BETWEEN THE LAKES & Hotel California
KAT trail big south fork and o&w road
Просмотров 7182 года назад
KAT trail big south fork and o&w road
2019 f250 rocky road outfitters rock sliders
Просмотров 1,1 тыс.2 года назад
2019 f250 rocky road outfitters rock sliders
2017 F150 OVERLAND BUILD WEIGHT ???
Просмотров 1,8 тыс.2 года назад
2017 F150 OVERLAND BUILD WEIGHT ???
what happened to the followup video on the RedArc
How did the redarc perform? Any issues?
Any specific reason for the H pattern? I'm hoping to save on costs a bit and am considering using a single 1/2” pipe down the middle, rather than the H shape configuration and wondering what difference it’d make.
Nice video! We love driving trails with the top off, but you definitely have to watch out for the mud.
Good video! I need to get down there.
Why do people use spade bits instead of hole saws?
Yall had a great time!!
I knew it the whole time.
Nice setup can’t wait till it’s done
Thanks
I bet I know what camper you're getting.
I know this video is old but do you have a lift on your truck and if so how much of a lift?
I like the bumper.
Looks good Denny
Good times
Supppp denny
Cool project. I made one but I used a single pipe in the middle of the box. I used Citristrip to strip the old paint off the can and painted it with high temp paint.
Are you happy with the single pipe down the middle, opposed to the H pattern? I’m hoping to cut costs and not need to by all the couplers and adapters if the single pipe is sufficient. Also, how did you remove the paint? It’s such a pain to get off
@@ZachBatchelder yes. The single pipe down the middle provides plenty of flame. To remove the paint I used a product called Citrisrtip. I applied it and let it sit for 24 hours and it softened the paint up. I used a putty knife to scrape it off. Stripping the paint off was the worst part of the project. Lol. I then painted the can with some high-temp paint. I’ve only used it a couple times since I made it and the paint looks like it’s holding up so far.
@@timjchickthanks! I’ll get some citristrip. I removed the paint from the exterior pretty easily with a wire wheel on an angle grinder but the inside of the box is too hard to get to. Hopefully the Citristrip will work. Thanks!
@@ZachBatchelder it still was a pain to remove but the citristrip made it a lot easier.
I think the intake holes on the air mixer are generally intended to be on the propane side not the burner side, but the air mixer seems to work that way. Try flipping the air mixer.
Thanks.
How strong is your pump?
Just a pump from harbor freight
That's how it's done. Nice job. I only worry about the rubber hose being close to the heat source. One add on I would do is to get four of those plumbing straps and screw them at each corner on the bottom of the can for legs to raise it up a bit for cooling and air flow under the can. I'm making one for sure...
I just set the lid under it and the rubber hose dose get hot but as long as u don't touch it wile it's on it works good
Good video. What size holes did you drill.
1/8
Do you have links for the Air mixer and reductions for 3/8 pipes to connect the propane hose ?
FYI you might want to look up how the air valve works because having a reducer right after it. Really reduces its ability to work, specificity saying a straight piece is required right after it that it comes with. As well you can’t just paint over the original can paint as it will fail and cause your hi temp paint to come off
Ok I will look into it
thanks for the video - how tall is the unit when open? hoping to put under a rack like you did here.
The box gets hot on the bottom because the rocks are being heated
i was thinking about throwing the rock away
Hi great video, how have you found the rain with the vents ? Do they leak if you leave them overnight ? or have you found a way to cover them ? Thanks
If it's a hard rain they will let some in when open I just make sure to close them while it's raining hard
I’m not sure why people cut the crash bars. You just loosen the bolts as far as you can then cut the bolt and pull the crash bar out.
There is more than one way to do everything dose not mean the way I did it was wrong.
Seems like fridge is pretty heavy is there a reason why your fridge is on driver side vs passenger side with gas tank being on driver?
Because all my other stuff is on the other side
Did you ever put a final parts list together for this build. Looks like it works great and ready to build one of my own
Bo i did not
What size lift
6 inch
Thanks 🙏 that video help me a lot
Looks like another good time had by all
It was fun thats for sure
Can I ask where you got the winch plate from?
what size pipe r u using
did u use a orifice going from The propane connection at the box to the burner.
are you able to have one fair suck air in and one fair pull it out? I read somewhere that you can't change directions on these. Thinking about getting 1 or 2 for my tacoma cap.
No u can't I just open it and leave one fan off so the air can come in that one
Hi you need more airflow to burner, then you will have a clean blue flame, yellow flame equals to much gas not enough air But nice build anyways
Thanks I will try that
Perfect gas
Cool video! Love to see what an F150 can do, I have a 22 XLT powerboost 4X4 with Cooper rugged trek & hope to go out west and camp on BLM lands, you have a great setup, I am Ben from Frankfort 60 and retired
Thanks
If you get a 40mm ammo can, it is easy to store the hose assembly, and 2 1 pound propane cans for portability. Also, take the rubber seal from the lid, and it acts as a stand for the whole unit keeping it 2 inches off the ground. Lastly, drill a hole for lighting it easier.
the hose fits in this box also
Amazing ideal....Peace
Nice build sir! Was wondering what size btu air mixer did you use for that build? I keep getting multiple sizes when I look online and it’s saying : 90,000, 150,000, and 300,00 btu’s.
It didn't say I just got the first one that came up
Love to see another full size truck out playing! Great video!
Takes alot to turn around thats for sure
Great video. Love your content
Thanks
Ples opin in the tuop befor intir gais the fier yilo
Noite fire yiole
Actually a good idea
Thanks
Looks like a good time Denny
it was
Brilliant I don't know I've never thought of that you sir you are going places
Thanks it helps
Texas?
Nope ohio 2 tomorrow without the wind chill
Good stuff, not bad. I'd back that hose up a little away from all that heat, but that's just me.