Видео

is there a part 4 that shows the system operating?

Awesome

What about the door only opening from the inside. Vacuum line or what?

Has anyone ever told you that you sound like Steve Carrell

Test the purge valve see if it’s stuck open. If not run smoke on the bottom line of the purge valve to the canister watch for leaks from lines , canister, gas cap , or tank etc…

مرحبا اخي عندي عند قفل وفتح سيارة عند لوحه تحت مسجلة موسيقى عم يضوي ضو عند قفل فتح ماسبب اضاء ضوء كان لان يضوي ضهر فجاه ماسبب ارجو رد

Great Job 👍👍👍describing and demonstrating your steps to change out Hangers \ Shackles. But I don’t see a difference in Stow n Go equipped Town and Country hangers or non Stow n Go Town and Country hangers? And yes you are correct Shackles are the same.

My opinion you don't show how to remove the filter air and explain how you take off the wires one at the time and put it in one at the time also to explain to beginners so as not to make mistake

Did the NGK sensor work well? Any issues with it afterwards? Later on? And do you have the part number or link for the power guilt socket? Or the NGK sensor? I have a 2007 dodge grand caravan SXT

Thank you very much!

I have the problem that disconect the sensor and the light dont came on what can be

Great idea! What mess that tape can make. It's been my first experience at removing & I hope never to have to remove any ever again! TY 4 VIDEO

NEVER buy a reman rack. Just replaced mine the 2nd time this time w a new one. Took me 14 hrs of hell in 100 deg heat. And just get the wheels as strait as u can bc it will need an alignment anyway. Counting turns is useless

My monkey wrenches a lot bigger I hope it fits it looks tight in there thanks for the video real helpful

Thank you very much, worked perfectly as described!!!!!!!

Great video, I've got a 2004 Grand Caravan 3.3L that is starting to drip PS fluid down the driver's side tie rod. So I'm thinking I've got a rack replacement in my future. Your video is excellent, and funny thing is I was just looking at the price of racks on RockAuto. After looking at them more closely I decided to go with the Edelmann even before watching your video, nice to see confirmation here that I was on the right track. Got everything you recommended, including air, impact tools and sockets. Just have to check if my 18mm Gearwrench open end wrench is long enough (I also have the same Craftsman wrenches you do). Hopefully the differences between my 2004 and your van in this video is not going to be overly significant.

Good video but a few things confused me - Why are we suspending the caliper vs just setting it down gently? Will the break line not have enough length to do so? And what is the purpose of compressing the old pads in the caliper once they're removed? You mentioned the compressor to compress the caliper piston, but I'm not understanding the purpose of this step.

Four years later this video is still very helpful. Thanks

Thank you so much for posting this! The idea of putting the maintenance labels on the filter box is genius!!

I'm amazed you even get that much light from the top onto the oil filter housing; it's just a dark vertical cave every time I change my filter. Is this motor the 3.8 like mine or a 3.3?

You can erase any EVAP codes after filling the tank and you won't see it till it gets down a quarter on the fuel gauge. After erasing the code, and you see the 1684 code which tattles on you for doing that, if you crank it 50 times, that 1684 will also disappear. It has to be full crank and run till the bell dings and instrument cluster is reset as normal driving. Then drive it about 100 miles and remember to refill the tank each time. Some inspections also check to see if it's been driven at least seven times, or once a day for a week. So long as you keep tank filled each time you drive it before cranking it again, then it will pass emission test. I got my 2003 Grand Caravan pass veip several years that way.

Before you do anything YOU MUST disconnect the battery & keep the doors closed if you have an SBC brake setup on your W211. If the system is activated while you're changing pads or rotors, the loss of fingers is a distinct possibility!!!!!

hi,i cleaned up my starter and when i placed it back i made pretty bad shortcircuit,car won t crank anymore and alternator doesn t charge,(started the car by pushing it),i have this code,how bad could be?

You could also use a bit of heat shrink tubing to cover the center pin on the relay.

I just bought a Cardone Rack and Pinion for my Silverado from Rockauto. The part was leaking oil right out of the box.

I always remove the brake fluid Reservoir cap when compressing the caliper, that fluid has to go somewhere and you risk blowing a line.

I used your vid and got all the things from Autozone and got it done. Thank you, dude!

Thanks for the heads up

Worked like a dream thank you bro

I call mine ,,,, go cart... fun to drive tho....

tnks

Thanks 👍

Water pump hasn't failed on my 06 T & C (yet) but I'm so glad to find this, I went through hell with a Caravan I had a few years ago with broken bolts on the pump. So now I'm prepared!! You were there for my front brake pad install I just wrapped up this morning 😊😊😊👍👍👍

This is the video I needed to see after viewing several others which weren't quite right for my 06 Chrysler Town & Country. All the others had the spring retainer clips, but mine doesn't and it's identical to your Caravan. I was stressed about that, having a 300 mile road trip ahead of me tomorrow. Hooray, I got 'er done!

i re-watch this video EVERY TIME. thanks for posting

What’s that tape on your airbox?

Thank you for this very informative upload.Your knowledge and experience is very much appreciated. Keep informing the people...

Is this rack replacement for dummies? 😅

I'm going to go play with mine

what about the front end of the leaf spring? not worth changing?

Great videos. I too would like to see your dash/center console repair and paint work video. Thanks!

Much appreciated! Love a fix that costs $0

burned out electrodes will fry those coils quickly too but at only 60k those are junk....

I really like the newspaper trick between disk and bracket when greasing pad slides area.

ruclips.net/video/xWtIe_xU160/видео.html

The little single white connector I believe is steering wheel controls. Multiplexed.

I'm ordering an Edelmann for my 2002 Camry from your previous comments it sounds like its a good brand?

Just happened to me today while changing the tires on a toyota didn't even get to torque it up to more than 30nm and snap and the bolt had rust inside the breaking point guess it was doomed to fail

All I can say is WOW! You taught me more in this video than anyone has in 20 years. Thank you! Subscribed.

Wow! It's that easy!!!??? 😮 💪 Thanks dude!