Видео

problem found in side lamp connector plugs - earth pins was melted , new wire and pin added...

Thanks

@@meghanapathak6157 If the mechanic has proof and has looked, measured, diagnosed the problem, then it may be... First you need to measure, test and then change something... this is my opinion 🙂

@@Thirrtyeighterr not common, but heapens sometimes, because of clogged water drains...☺️

the lamp leaks water, there is a crack somewhere or front glass not sealed correctly...

@@Game1Experts simple with brake cleaner or other fluid, in this engine - temporary solution, because there are problems inside the engine 😐

@autoelektricianEvaldas What's your problem mine is when the engine is cold I get white smoke car shaking and engine light on when the engine is hot the car is like brand new no shaking and no smoke I never cleaned the 2 variable valve Solenoid is it related?

@@Game1Experts White smoke like burning oil or antifreeze... oil and antifreeze at correct level?... These solenoids adjusting timing of chain... First thing must be correct oil grade... Need diagnostic scan for codes and live data...

solution for repair just bypass connector with wires or add new metal ends for connection...

@@ronaldbertin9455 don't remember correctly Avensis or Corolla +- 2005

yep, but leaded fuel created worse issues.

@@Laossutra the cause is unknown, it is suspected that fuel was poured from dirty containers 😉

If you have parts, maybe 5-6 hours or less...

Holy sheet..... my heater smells terrible when I turn it on and Im afraid this is the issue 😢😢😢😢

I got my whole dash out gotta replace the whole heater fan and the box around it because it caught fire

To nie przez drzwi, tylko pewnie zapchane odpływy pod aku i pod serwo. Nie odprowadzało wody i lało pod fotel

@@TobyRowles Przestań..

But did you not have to replace the alternator pully since this was causing the issue in the first place? And is it not called a freewheel clutch and not alternator pulley? or am I mistaken. Cheers

@adversaryforu9814 I have it sitting ready to go, just need to find the time to swap it. Apparently can be done without removing intake by manipulating it into place behind the intake, which will save some time (but probably end up with crushed hands). Yes, it is probably called alternator clutch pully given that is what it has inside. Part #31316804

@@TonyHamlyn Thanks for reply. So the clutch pulley on your car is seized then? Is there a way to check that without removing alternator? I saw the procedure to remove intake ( t6 seem a bit eaaier than 3.2), It is some work and old plastic is not fun. I broke my power steerring reservoir last time cause of old plastic.

Am going for this tomorrow

Have changed battery, worked on alternator still. No solution.

El. parking brake fault indicator

@@autoelektricianEvaldas thanks

@@vaidasvarnagys3867 šiuo atveju buvo vidurinis stop žibintas, įdėtas kinietis ir po juo užmiršta tarpinė, bet būna ir apatinės lempos arba nesandarios arba taip pat pro šonus leidžia į bagažinę, dar vienas variantas galinio valytuvo apiplovimo žarnelė kiaura ir bėga viskas i vidų- bet šitas retas variantas.... Pradėti nuo lempų!

@@autoelektricianEvaldas man net galine sedyne slapia buvo ir kai tik uzlyja pilna vandens

@@vaidasvarnagys3867 iki sėdynės gan tolokai, reiktų atsiardyti ir važiuoti į rankinę plovyklą, pilti vandenį, žiūrėti pro kur bėga,kur tikroji priežastis 😏

@@autoelektricianEvaldas aciu uz patarima 😉

Muito difícil ter concerto maioria dos casos tem que trocar ele fica estalado encima dos pés do motorista embaixo dos fusíveis que tu vai ver

Donde se encuentra la BSI

So you just need to weld the pin back on?

@@danielmuller6054 in this situation YES weld or solder ...

Taip, dažnas gedimas šitiems modeliams tiek priekis tiek galas...

If I remember volvo xc60 3.0 i engine ~ 2012

Nothing replaced there, just loctite screw and tighten... If oil leaking need more investigation... No video for that..

If I remember correctly ,it was bmw X5