Видео

2 out of 2 cook outside and stay warm at the same time

Your soup must be cold taking all that time to start eating.

I have the same. They work great. Liked your commentary describing these chargers.

I have a problem of my Nissan sentra 2004 when I'm driving it automatically off in the middle of the road sometimes the light engine will appear. Do you have any idea what happen?

Is this ok with 05 manual 5 speed ( how much cost you the crankshaft sensor) Thank you so much for showing us how

5 dollars at Sam’s club and best meat to use for pho is thin sliced eye round

Huge help! Thank you!!

swesome video, thanks, I saw the fork adjustment first and suscribed. Got a 2009 Dr200 -so practically the same bike-, been out of my way looking for an enduro-like tail mudguard, could you tell me what you got there? I think I dig it, did it work for you? thanks bro!

Do not use Shark Bites where they can freeze! They will pop off and then you got a flood!

Nice 👍🏼

I`m a fan of shark bite fittings, one note for future users is that shark bite doesn't recommend sanding copper prior to an installation. They say sanding causes scratches and could compromise connectivity.

What size is the pry bar/ flat head screwdriver did you use ? Great video by the way!!

hey man ive got mine out and got my shutoff installed on my incoming cold water. but when i turn on the sink it shoots out the hot water side… is this normal ? cuz closed circuit system being open? just confused

Great video, but I dont have the hose on the oil spout or the blue thing holding it. Do you know what size hose I need?

This was a major pain to do, everything was fine up until trying to get the two anchor points to line up. This turned into a 8 hours struggle fest no matter what was jacked up it would not align properly the only way I was able to get this to work was a ratchet strap around the knuckle, control arm and frame which required very little tension and bam it all lined up perfect... if only I had tried this earlier I would have saved probably 6 hours of fighting with this. Live and learn... good luck to anyone trying this part swap.

I'm absolutely sure this bike only takes 1 quart of oil. It literally says 850 mL on the bike casing...a quart of oil says 800 mL, but it's a bit more than that. Hopefully, this may save someone from adding too much oil..

Instead of holding with your knees when installing or removing the top cap hold the fork with the lower triple clamp on the bike. This will leave both hands free when installing the cap.

Why didn't you show the hook up??!!

I bought one my only concern also is the self-propelled. I have to go see if my belt was not on it. My front wheels looks different from your mower. When I lift up the front of the mower the wheels spin but it does nothing on the grass.😢

Amsoil #1

I've never used one. Thanks for explaining that the extra hose could be used for car tires if desired, but not necessary - that had me confused. And thanks for telling us where the fuse goes. Great tutorial.

What tires are those ?

Shark bites will out live most of us

Awesome video man, deserves more credit for this. My 2001 Nissan Sentra had me on the side of the road with this😂

Thanks for the video!!! Well explained!👍🏽

❤❤❤❤❤

All that kitchen and THIS is what he cooks?

Great video working on Nissan cars can be a plain in the (A word). I tell you I have a 2012 Nissan Altima 3.5 SR and I would never recommend getting a Nissan vehicle there CVT transmission are crap and the Nissan corporation is trying to keep people from working on there cars just to make more money for Nissan. Nissan in general ain't worth a damn as a car company.

Great video! Thank you!!

Dude is changing oil on a ship....mower is swaying up and down.

Put your noodles after you microwave so they wont be mushy

Now I'm going to give advice for future reference or anyone else is out there doing it start with the ball joint line up the backside vaults or the inside bolts rather and once you're done doing that put the ball joint in once the ball joints in try to get those back bolts lined up with the bushings as close as possible put a jack up underneath the control arm Jack it up a little bit it's going to be a bitch still I had to fight with one side really hard the other side went pretty well but it was a hell thought I was going to take about 4 hours to do both sides first I took about an hour second side about an hour and at that point I was still fighting the back bolts rainstorm came down took another hour from me and finally the rain stopped is a fresh mine that went back to it and well I'm doing that part now but I will still say the above instructions just seems to be the easiest way especially if you have a lift if not just make sure you don't jack up your control arm past the height of your jack the last thing you want to be doing is hammering away on a control arm that's holding all the way to the car p cuz the control arm won't move first off second it's very dangerous have fun

where did you buy your parts

where did you buy your parts

Your videos have helped me a lot. Thanks for sharing. This was one of the hardest things I've done recently because of the location and angles, but I was able to get it done because of your help. My tip was to hold the sensor with my left hand and use the smallest and thinnest flathead screwdriver with my right hand to poke it through the gap and twist it gradually, which created a small gap and I was able to get it out. I tried all the big, wide ones, all the pry bars, all the specialty tools, and nothing worked.

Cuando debo camviar el aceite de transmision en mi maquina toro

When I was in the 6th grade back in 1985, I took a small cargo van size yellow school bus home every day. I was unfortunately the next to last kid that got dropped off at the end of the school day. The third, fourth, or the fifth kid to be dropped off on my school bus route, happened to live on and be dropped off at her house on Blackbird Lane by my school bus!! What a coincidence that it was the same year, on Blackbird Lane where my friend lived!! I am shocked, now that the host of this video telling us about the murder on this very street from 1985. My school bus route had about 12 total drop off locations in the North East Dallas area. I never liked to ride the school bus, but it was better than walking home, and I had a nice bus driver. Do you know the address of the house the murder took place at by chance?

We bought the tent after seeing your review. And we love it!

I’d like to suggest in future videos that you include that the spark plug needs to be disconnected. Not necessarily removed, but disconnected to ensure there is no accidental start of the engine while you’re doing this.

Thank you for actually mentioning to screw it on to the valve fitting because I was driving myself crazy trying to figure out why I’m letting air out of the tire

Difficult mower bag gets heavy mower wants to lean back. Self propel is weak. Engine is fairly strong. So far not a good buy FOR ME.

It’s 5 dollars in store I’m not buying that

That's nice. Wish it had a power source hole. But im gettin'er anyway!🤙

Helpful I've done it once before, if the sensor doesn't fix the problem it might be the wiring harness, there's also an identical sensor on the top of the engine.

Need a tac light would have been brighter the light was dim but thanks for the info

Junk Dont buy

whats the difference between 4 cycle 10w30 and 10w30?

Did it start right out of the box? I just got one and it wont start. I use these mowers 3-4 times a week so am wondering if it's a defect.

Why didn’t you just charge the battery in place? Why did you have to remove it? Does it ruin the electrical?

Any other alternative for oil