Видео

Question, I can't find a video. Once the four nuts are removed does the box just drop below the bolts and then slide off the main shaft

Where does the temperature sensor attach or go I removed my furnace to clean and fix , got it working however the thermostat doesn’t turn off the furnace when set on low heat even during summer heat when hot in camper , I don’t know where the thermostat sensor was when, I removed the furnace ?

This video was so helpful. I just bought an Apache where one side wouldn't lift. I thought it might be the chains based on other videos and facebook posts. I pulled the gear boxes. Based on this video i noticed the pins were not in place. Disassembled the boxes and found both pins bent in the bottom of the box. I pushed the boxes together and twisted the where the crank goes and noticed one was going in the opposite direction. Someone must have cleaned it and put the gears in backwards. So one box was going one way the other box going other way. They must have been fighting each other and bent the pins. The previous owner said he always just pushed one side up while it was being cranked up. Pins were $25 versus $250 for the chains. So glad that is all it ended up being. I could not have done this without all the insights in this video. Thank you!!!

Just bought a Apache project. Can you answer why both my gear box's turn 1/4 inch and stop abruptly? Like it's locked. Is there a lock on the box?

Do u have a link for those bearings

Just one screw to hold the burn on !

This is so helpful to me. Thank you for taking the time and sharing your knowledge.

Awesome! great info! This noob agrees with Jena!

Thanks Lee, my pin in the center gear box is bent, any suggestions on where I can get a replacement?

Ha! Thanks Lee! Very good info for the noobs!

Thanks Lee!