Видео

This is a Vitamix Blender, that was being used in a cafe, it would regularly trip the reset switch until it blew the fuse within the reset switch. I suspected that the motor bearings were worn out causing friction which would cause the motor to draw too much current and causing the blender to trip, in this video I show how I replaced the motor bearings

I demoded one of my two Pi 5 where I had replaced their Ram chips with a 16GB ram chip which is so far unsupported. Here I had removed the 16GB chip and replaced it with a 8GB ram chip.

The Pi 5 requires 5 Volts at 5 Amps to operate without throttling, I didn't have 5V 5A power supply but plenty of PD wall adapters, I used a DC to DC Buck converter and a 12 volt PD cable. the PD cable to trick the PD wall adapter to output 12 Volts at 3 Amps and used the DC to DC converter to output 5 Volts at 5 Amps.

I modify a Pi 5 by removing the original 4GB RAM chip and soldering in a 16GB RAM chip. After reaching out on the Raspberry Pi Forum I got help on how to Debug my Pi 5 and was able to confirm that the 16GB ram chip was soldered in correctly. But would assume that a firmware change will be required in order to make this Pi 5 functional.

VW EOS 2.0 FSI EGR valve faulted with an engine light on, found one of the gears broken, depending on which gear is broken you can flip the gear so the valve can continue to work, was not the case in with my valve

a repair of the climate control flap motor for a VW, the gears get worn and start to jump the teeth which cause the grinding noises you hear from underneath the dash

Does your toilet sound like its constantly filling up and there is water leaking into the toilet. well it could be the flush valve or the float valve. my case it was the float valve.

ALL EASA Part 66 B1 and B2 Module Notes and practice questions with answers, for aircraft maintenance engineers. Buy now and download: easamoduledownload.com/

working on VW EOS with a side airbag fault, the fault is caused by a high resistance within the squib circuit. I used a 3.3 ohm resistor across the squib wires to trick the computer into thinking the circuit is correct. I cleared the fault using an OBD device. clearly your affected airbag will never work once its disconnected so get it fixed. this trick is a short term solution to stop the anno...

Billi quadra water system, developed a slow leak from the water tap and when changing the filter. leak was caused by a failed inlet water solenoid inlet solenoid P/N 857646 cold water (without restrictor) P/N 857647

Wiring connection's from a USB 2 cable (standard type A) connected to a USB type C cable. Your cables may be different.

In my apartment a new Vaillant ecotec pro with a remote thermostat had been installed. the hot water never got hot just warm at the best of times. Using D.06 code under maintenance settings you can see the target cylinder temperature(if active) mine was set at 35C found that I could only change that setting on the remote thermostat. hope the video helps.

His battery is low and he's trying to return to his charger so I blocked his path with his cube. Now watch my Problem solve his way out of this little test.