Видео

I know this is late but that not transmission cooler lines.

I just replaced the washer tank in my father in law’s 2014 E 350. This video was very helpful. Like some others, I also had trouble getting the white cap that houses the coolant lines to seal against the new tank. After a couple of failed attempts, I slathered the tapered washer with liquid hand soap. That made it a lot easier to push the white cap on to the bottle and get it to seal. With the new tank bolted in place, I was able to reach one hand behind the tank ( the side nearest the front bumper ) to hold the rear of the cap down, that push the side of the cap nearest to the front tire down into the tank. I also found it easier to disconnect the wire on the front sensor, remove the old tank with the sensor in place and deal with changing the new grommet and sensor into the new tank on the bench. It’s a tricky job, but thanks to You Tube, I got it done 😊

Do you know how to change the driver side headlight washer nozzle ?

How much whp this get you to? And what’s the 0-60 like?

The Rotrex oil should be changed every 2 years/50,000 miles, whichever comes first. Not every 5000 miles.

Any insight to removing the driver headrest?

Thanks!

Great video! Do you know how to remove inner parts of the cup holder so i could take the rubber mat out

What was the long term review / reliability!?

For 2010 E60's, there are two Philip head screws holding in the ventilation control panel.

Hello...4 years have passed but i hope that you remember. What size pulley did you use with the supercharger? Also, was the engine stock?

Thank you! Very helpful. Is there anyway to fold the captain seats down all the way?

I have the same issue with the same car seat, but I have bench seats

Thanks, same issue with the carseat ❤❤

Hello and thank you for the video, I didn't imagine it was that easy to access the CIC. Is there any device that hold the front panel on the CIC or can we just "unplug" it? Mine has 2 gripped buttons and I'd like to replace it

I love you bro my BOTTLE IS LEAKING SO THIS DEF HELPS THANKS BRO BLESS UP

hey what is this screw and what size is it because I lost mine :(

Mind me asking, what is the make and model of your double din receiver? Thanks!

Hi There. Where was it leaking from? The pump gasket grommets or crack on the reservoir itself?

Thank you for the great video, Michael! It made the replacement much easier!

Did the KIT comes up with ECU?

Hi, I know I'm late, but do you remember cutting any of the steel in the engine bay or needed to make any intervantion on the frame? I'm thinking about buying a rotrex kit for my nb1

Is the armrest real leather ore the artico fake leather ? I can buy one from eBay and like to know please..

Hey, nice video and thanks for sharing. Where did you install or place your IAT sensor?

The most daunting part is getting that white lid snapped back on, it does not go on without a fight and it didn't look to me like you had it on correctly, I could be wrong but from what I saw it didn't look locked down.

はずしかたがわからなくて、苦しんでいましした。とても参考になりました。 ありがとうございました。

You might’ve swayed my mind about going turbo. I might have to pull the trigger on a supercharger.

I am going to be purchasing this kit for my 2002 Miata. What AIT sensor did you use and how did you go about mounting it?

Thank you very much for this

Outstanding video Michael. I'm in the process of doing mine and my leak is in the same place as yours (along the seam of the container). I was told you can also use 3M Marine Adhesive Sealant on the leak without having to replace the entire unit. Just want to get your thoughts. Thanks!

Thank you! I’ve been wrestling with this thing all day today You showed one or two steps I didn’t even think of. I keep remembering all these older Mercedes I had where the tank was visible in the engine compartment and we didn’t have to do all this stuff

Thanks for the video. One question the music is starting to cutting and suspect the HDD is going bad if i replace it do I need to code the new HDD and do I need to install a OS to run work in the car?

Thank u man 😍👏🏻

Thank you for the video! Mine does the reboot thing as well, by any chance do you know if the CIC would stop rebooting but still work playing music via AUX if I remove the HDD? I'm not interested in using the navigation or anything, just want the CIC to stop rebooting while playing from AUX or radio

How’s the Miata today? I have a 2001 vvt miata Thinking about going with this setup. Also what size injectors did you go with? Think I missed that if it was in the video.

But? No AC right??🥵🥵

Legend is the only word!!

Hand in the way. 🤨🙄

This works perfectly on 2014 ML63 with M157 engine

Thank you so much.

Can I please have this car I’m in love 😍

Thank you!!!! I noticed the car was acting weird - popped open the hood - and was able to see the issue which was the intake air hose! This part wasnt even mentioned in the operator's manual. Very grateful for this video! Ordered and getting it replaced tomorrow!

I'm thinking of getting this kit or something similar did you have to delete the ac ?

My problem is the spring loaded cup holder on this model. It seems like somebody opened it pushed it back in without aligning the spring loaded flaps. I cannot fix it. Any idea how I can fix this? Thank you.

I have a 2013 gl63 amg will it be the same method to fix it?

A coworker has one on his NB1. He's running an E85 tune on it and it goes like hell! My NB2 feels so sloooooowwww after driving his!

Does anybody have the number for the name of the place where I can get it intake hose for my Mercedes

Bravo super et Merci pour votre Tuto "bien expliquer"

I was replacing engine filters and mine got even more torn up after and today I have a cel on, could it be because of these being torn ?

you can replace the whole cover / trim with carbon fibre these days