Видео

Thanks! Schneider Modellbau. www.schneider-modell.at/

@@dk-rc585 Thanks for the link :-) Good luck with the model. It is amazing!

ruclips.net/user/shortsWheOdi4Zmtg?si=05sM8cOVVW9CAcXW ruclips.net/user/shortswDg7pi7rAOs?feature=share Thanks 🙂

Hi, Yes on one side only a little bit, it is so less that if you dont cut, the spark plug will have contact to the cowling but not more. Good solution will be, cut it and make a layer gfk from inside and puah it a little bit outwards. Than you can paint the outside and you have only a little bump vissible.

@@dk-rc585. Thank you for your help. Very much appreciated.

Thanks! :-)

Ansagen wurden deiner Anregung entsprechend angepasst :-)

sure :-)

Hi, i remember, i seted it like in the usermanual.

APC 18x10

Thanks, but now with a stronger engine :-) ruclips.net/video/CZ52uDdkOlQ/видео.html

@@dk-rc585 how did you find the fg60r3?

@@gman2060 very good engine, as long you have the version 2. This engine is now in my Lysander: ruclips.net/video/l2-u1-51S4g/видео.html

Hi, Thanks! I have the old ACCST setup. Imortant is you need a rx8R (the R stands for redundancy) receiver with the SBUS IN port. There comes the signals in form The XSR, receiver which is the slave (from this you only need the SBUS OUT). At the binding process, you connect all together, than you bind at first the master as usual with telemetry ON and then the redundance receiver with telemetry OFF! Thats also important, because you can only receive telemetry from one. At the end both receivers light up with a green led and its ready to rumble :-)