- Видео 1
- Просмотров 651
Samantha @ Lock Labs
Добавлен 23 мар 2023
Triton Plus Key Machine S8 Flip Blade Creation Jaw Calibration & Test Key
Introduction to using the S8 jaw. This video goes over calibration, creating a flip key head, and punching a hole for Autel remotes.
Measurements:
B106 tip to line- 40.02 mm or 1.575 inches
TR47 tip to line- 43.11 mm or 1.697 inches
Y159 tip to line- 39.47 mm or 1.554 inches
0:00 S8 Jaw Calibration
1:50 Locate and Enter S8 Jaw Menu
2:40 Preparing & Measuring Key Blanks
4:30 Clamping Mechanical Key
6:05 Start Cutting the Key Head Off
10:30 Clean Off Key & Jaw
12:00 Cutting Hole in Key for MFK/Autel
Measurements:
B106 tip to line- 40.02 mm or 1.575 inches
TR47 tip to line- 43.11 mm or 1.697 inches
Y159 tip to line- 39.47 mm or 1.554 inches
0:00 S8 Jaw Calibration
1:50 Locate and Enter S8 Jaw Menu
2:40 Preparing & Measuring Key Blanks
4:30 Clamping Mechanical Key
6:05 Start Cutting the Key Head Off
10:30 Clean Off Key & Jaw
12:00 Cutting Hole in Key for MFK/Autel
Просмотров: 652
These videos are great. I have a triton and can figure most stuff out with trial and error but having videos really helps. I never would have known that I had to download onto a thumb drive new software and remove the old one to upgrade without these vids. Thanks Sam!
You're very welcome! :) Once you are past that initial manual update, you should be able to download updates normally with just WiFi connection. There are definitely some features that take a bit more trial and error than others. Even I cut my first flip blade key with wrong positioning!
I don't understand why we would have to press Cancel during a cut. Should the programming be such that it automatically stops when it should? That said, thank you for posting this. I've been very curious about this process.
The only reason that you would need to press cancel is if you don't want it to cut the groove for the roll pin so the area will be flat. Otherwise, you don't have to stop the cutting process. Unfortunately, there is no way to get rid of that groove at this time
@@Samantha-LockLabs Ahhhh! I understand. Thank you!
Cut tool pin are today for Xhorse remote for Honda using standard measurements in computer already. Need to either create me a Cheat sheet and laminate or either see if there’s a way we can submit settings, possibly tips they can embed or include with app on phone? My roll pin went in fine but key was to short and also key was loose when retained by roll pin. I do a said amount of switchblade keys as long as there’s not a shifter adjacent to the key hole as can cause issues.