Видео

Shingle manufacturers are all garbage in their own way best I’ve seen yet is the timberline I don’t care what anyone says I have never had a problem with them yet had problems with every other type not sealing properly in cold or losing the seal due to poor sealant quality.

Only trash shingles need a plastic strip for nails to hold em down it’s an indicator that the tar line is nfg from the get go if you see that tape on a shingle don’t even buy them tellin you now they might hold for a decade in a calm area but wind and dust will eat those tar lines away till all that holding the shingles down is that plastic strip and fat good that will do on a windy rainy day with the tabs flapping

In California before the system goes online it has to go through several rounds of inspections on the state level. What state was this?

✅ Get a no-cost-to-you roofing or solar consultation! 👉 www.augustroofing.com/

Theres a reason some insurance companies are starting to drop homeowners that have solar panels mounted on their roof. Go standing seam w/ mounts that dont penetrate the roof or forget the idea of solar.

Get a no-cost-to-you roofing or solar consultation! 👉 www.augustroofing.com/

Paying a rate for power that’s 30-50% less is always worth it. CA utilities have increase their prices by 50% the last three years and they are going to double in another three. Already been approved by the California public utilities commission.

✅ Get a no-cost-to-you roofing or solar consultation! 👉 www.augustroofing.com/

Get a no-cost-to-you roofing or solar consultation! 👉 www.augustroofing.com/

Nothing like hand nailing

🏠 Get a no-cost-to-you roofing or solar consultation! 👉 www.augustroofing.com/

🤝

🏠 Get a no-cost-to-you roofing or solar consultation! 👉 www.augustroofing.com/

Very interesting

🏠 Get a no-cost-to-you roofing or solar consultation! 👉 www.augustroofing.com/

I lease a Sunpower system that I pay $3k a year to save $1 k a year, foolish me for believing a Sunpower salesman

Probably is an homeadvisor lead and the contractor is qualified from Angie. 89% of contractors on homeadvisor and angie are not qualified not even to drive cars ofcourse not roofers!

🏠 Get a no-cost-to-you roofing or solar consultation! 👉 www.augustroofing.com/

Get a no-cost-to-you roofing or solar consultation! 👉 www.augustroofing.com/

Get a no-cost-to-you roofing or solar consultation! 👉 www.augustroofing.com/

Good overview PVS6 so much more reliable when Ethernet connected (needs USB adapter as of approx Dec ‘22 h/w revision). Running an Ethernet cable is sometimes a hassle, other time really easy (as mine was), and much more secure. Really PVS6 should be indoors for security reasons as well (typically in garage, other side of wall from solar sub-panel ymmv) Beware installers not accurately recording panel serial number to actual roof placement, which can be relevant if shade (chimney, tree, etc) applies. I had this happen with SunPower employee installers, and took them 10 months to fix their mistake…

🏠 Get a no-cost-to-you roofing or solar consultation! 👉 www.augustroofing.com/

Im 53 and i would smoke that dude with 20+ years of experience and i can lay a square an hour or better hand nailing useing a 3 row nail stripper 😂 + you guys are sitting watching bet you all couldnt roof a dog house😂

The nail you consider low was actually the best placed one. Owens has a 3/4” lap of which is considered the “sweet spot”. This is the area where the two parts of the shingle is laminated together and the only spot where the nails should be. Most of the “sure nail” strip is above the double lamination. Nail a shingle on in “sure nail” strip and another in the double lamination and then pull them off, you’ll find out the double lamination nails are by far the superior hold.

Get a no-cost-to-you roofing or solar consultation! 👉 www.augustroofing.com/

Awesome job mate.

My system is similar, but I think mine is even better,my flashing piece has a built-in 1 1/4" round riser built on it and the lag bolt goes thru the center, and the U shape screws over the top, that can never leak. You actually have to unscrew the U top to get to the lag bolt to remove it. The panels are actually about 6" off the roof, better ventilation. 4.8 kw enphase grid tied w/sunpower premium panels, Installed Oct 2017, this system has consistently produced 5.5 Mw every year, 25 yr warranty top to bottom. If any of my panels drop more than 3% of there rated power in that time they have to replace it for free. I'm very happy so far.

✅ Contact us today for all your general contracting needs! 👉 www.augustroofing.com/

But you're numbers are off a bit When you connect the panels to the grid or battery you can only get and use less than 20% of rated output It's called ohm's law Electricity is like water you must overcome the incoming voltage or pressure if you will Average line voltage is 240 and thanks to Enron maximum line voltage is 274 you only have 34 volts to push the electrons in the grid or battery amps Volt multiply by amps equals Watts. Check it out yourself be careful of course with avomwith amp clamp at the meter or output of inverter or battery Measure the volts and amps multiply the results and you will see the actual what's going in which will be less than 20%

I love it!

Get a no-cost-to-you roofing or solar consultation! 👉 www.augustroofing.com/

Get a no-cost-to-you roofing or solar consultation! 👉 www.augustroofing.com/

Very helpful explanation. Thanks!

Get a no-cost-to-you roofing or solar consultation! 👉 www.augustroofing.com/

I've been a roofer 36 years, the first 5 of those years I hand nailed.

Get a no-cost-to-you roofing or solar consultation! 👉 www.augustroofing.com/

Two beers per row 😂

👉 Click on the attached video to watch Robert's entire review, and get a no-cost-to-you roofing consultation!

Have the solar AND roof experts install your system! Don't risk poor customer service or installation. Get a no-cost-to-you solar consultation with ARI here 👉 www.augustroofing.com/

Get a no-cost-to-you roofing or solar consultation! 👉 www.augustroofing.com/

Some roofers get the job and works few hours or a day and then sends few guys from " labour unlimited" or " work today - paid today" type of companies. Most of those guys have no experience. That happened with our town house of eight units. Second roofer did the band aid job with glue. Entire roof had to be done in next season.

Get a no-cost-to-you roofing or solar consultation! 👉 www.augustroofing.com/

👉 Still haven't gone solar yet? Click on the attached video to learn more about the home solar installation process!

👉 Still considering going solar? Click on the attached video to learn more about why a roofer like us should install your solar!

Get a no-cost-to-you roofing or solar consultation! 👉 www.augustroofing.com/

I was an electrician for vivint solar and they had kids that never held a hammer putting them up. I always told my close ones to not do solar through a big company

Ground mount only way to go.

Get a no-cost-to-you roofing or solar consultation! 👉 www.augustroofing.com/

👉 Click on the attached video to learn more about what makes us different and get a no-cost-to-you consultation!