Видео

Full video app channel par dekh lo

ruclips.net/video/OoqrMwVIjj4/видео.html

Thank you sir

Ok

Sir channel PE aap video dekh lo

ruclips.net/video/L_S_BlX8zjU/видео.html

Control is through nc contact suppose a relay whose current seeting between 1-5 amp. and current seeting is set at 3 amp. If the current value is equal or greater than 3 amp. and continuous increase than after some delay overload relay trip action occur It's NC contact become this time N.O and N.O become N.C if you want trip feedback use N.O contact than after reset again Nc become NC and NO become NO

NC contact is used for tripping

@@electricaltechnical881 NO contact which purpose is used

for tripping feedback

Ok

Thanks sir

If you set the time 30 min on /30 min. off 1 - change the dip switch settings for off time 1,2 dip switch for on time 6,7 dip switch for time setting in hour 1 dip switch is off and 2 dip switch is on (off time) 6 dip switch is off and 7 dip switch is on (on time) after that select multiplier If you choose multiplier is 1 3 and 8 dip switch both on Total time adjustments is done by potentiometer knob up for off time and down for on time setting total 10 div. time setting in hour 1div. =0.1 hour 10 div.=1 hour For half hour on and off both the potentiometer knob is set on 5 div. 5×0.1=0.5 hour ,1hour =60. min. 0.5 ×60= 30min that's all

Sir if phase wire is connected to common and neutral wire is connected to running winding with capacitor 2. If neutral wire is connected to common and phase wire is connected to running winding with capacitor

Bhai g bilkul channel Pe app video dekh lo

Dg contactor is hold only when relay is off state control phase of dg is connected to relay common point and is out through nc contact of relay is in series with nc contact of grid contactor and contactor dg is on

2 , No dg is not in on condition dg run in auto when power failure

Ok dr