Видео

Are these Ziptrak blinds from Australia ?

Mine has 2AAA batteries and no button at the back. Any thoughts about what to do?

⁠hi, i was able to fix it but took me a lot of time of trial and errors to try to bring the screen into the range where turning the rod will cause the motor to work. When you get to a point where the motor will jog, you can then control the motor. You need to make sure that you turn the right limit screw left or right when the screen us at the bottom and when its at the top.

How do I change the direction? My blind goes down when I press up and viceversa

Hi, what do I do if the motor keeps spinning up? Does not stop.

Hey Mate , I am having a bit of issue with my Dooya mtors , There are 3 of them working on single channel remote . With no reason 2 of them stuck closed . One is working fine . I contacted the supplier and was advised to get multi channel remote ( same as your video ) and program 2 of them to new remote . I have tried all trick in book and guidance from you video . But they are stuck . The made all proper beep sound of connection but dont move. Do you know some one who can come have a look and help . i am in south west sydney. Thank you

Cheers mate. Very helpful.

Top blokes. Helped me to sync my remote and Dooya motor

Uuj

dziękuję za film. prosto i skuteczne to pokazałeś. Pozdrawiam z Polski :)

How to reprogram a new remote because I have lost the old one

i have the single and my awning is not working with the remote - there is a charger but I don't know where to charge the awning?

Hi, Is the single channel remote a Bluetooth one? I'm trying to integrate it with my smart home but couldn't figure out what device should I buy to control it rather than using the remote

Have you guys got anything that does Smart Blinds?

Thanks from Russia for your video!

Thanks a lot. You helped to fix my Dooya awning.

can u teach me how to channel 3,4 curtains, so that i can just use one remote. thanks alot

Your video is great but do 1set one remote program then go to uther remote

Hello, I have a awning (right side motor) made with the dooya turbular motor. I got the remote set up and I was able to setup the closing limit however I have tried many times to set the limit for how far it opens but I does not seem to work. I have turned the white circle clockwise and counterclockwise wise but nothing has worked. Any ideas why?

you have to be extra careful cutting polycarbonate because one wrong move and it can almost stop a blade and kick the saw back.

Is it toxic to cut polycarbonate indoors?

That music....

I had to cut 12 mm polycarbonate with a jigsaw, and a fine tooth saw melted the material and jammed after a few seconds, so i then found that a coarse (wood) saw worked faster and did not melt.

The hand saw makes sense, but I understand that cutting with a circular or table saw-even with a very fine blade-can melt the material, splatter the user with molten plastic, jam the blade, etc. ... No?