Видео

I got the bosch fusion ir and i know ford fomo and denso perform will so i shall come up with my result which is better....if its not the spark plug its just the car make a better performance...

It makes perfect sense to mount the valve this way but if you look on the diagrams you'll see that it's backwards. I've bought the right part from Febi and have marks with "motor>>" in the same wrong position. Anybody knows what's going on ? Diagram error and manufacturer error?

En los programas de mantenimiento de Mercedes no existe el cambio de aceite del compresor

Nice 👍🏻👌

Hey man, how did you remove the air filter box? Is there a bolt somewhere? I can't see it?

Buna cat ulei se baga am un CLK 200

Thanks, really helpful to see.

Did the kompressor(supercharger)had any problems before?

En francais svp

Yah jelas berbeda laah, Motul expert itu semisyntetis.. sedangkan yacco mvx 1000 itu fully syntetic Ester.. perbandingan yg tidak seimbang

How did you conclude the oil choice? normally they recommend ACDelco 12345982

My mechanic replaced the PCV & its hoses during compressor oil change out. Before this change out the engine oil level is 2mm higher at 2 minute after starting the engine & kept it idling at 750rom. After PCV is changed out the engine oil level by dipping is lower by 20mm at 750rpm. In both cases the MAF remain at 4.7 g/second vs MAF also remaing at 0.5bar. Throttle valve body was clean and the before vs after result is 17.2% vs 14.9% open. So was the crankcase's positive pressure is actually less than +50mm WC before changing out the PCV & hoses? In the dash the engine oil level indicator drops from 5.7 litre towards 4.4litre with the engine at 750rpm. Dip stick need to be 600mm from tip to its stopper. If the positive crankcase pressure is much high, the engine oil level by dipping, could easily be 100mm higher than before starting the engine? Yes no? Regards.

my sunroof slides keep sliding out any idea what could cause that?

YACCO 10w60 de motocicleta pare sa fie peste motul 10w60, e un ulei prea putin cunoscut dar foarte performant. Tu ce parere ai?

I have same laguna with same engine and it is best car i ever had

do u have to remove compressor?

Can you tell the part number for the bosch pump?

What's the parts number for the new pump?

Thanks for doing this in English.

Good video. I will change this set of PCV and hoses during plannes oil change for the compressor in this coming March. For now I am getting a slight positive pressure, of less than 100mm positive H2O pressure, out of the opened oil filler cap, while M271 1.8 litre SC engine is running at idle of 750rpm. Air intake manifold pressure was at -7.3psi while air flow is 4.5litre/second by the MAF. This equal to air intake flow of 270litre/min. I was expecting that some air should be sucking thru opened filler cap and then routed out of the lower crankcase via the hoses & PCV and into downstream of throttle valve body. I am expecting a small spring inside the PCV holding a seating tension of about 2 psi. So -7.3psi in air intake manifold is having plenty of delta p for sucking blow by gases thru the PCV and at same time provide a slight negative pressure inside the top valve cover. Any comment is welcome. While engine is idling and the oil filler cap closed back disconnect the black breather hose on top of valve cover. Connecting a garden hose, and route into a pail water, it is venting blowby gases at roughly at 4 litre per minute. Thanks

Which oil is thicker?

Din ce oraș ești ?as fi interesat pentru partea de service! mulțumesc

Even though engines have sludge there's some mechanics and some shops that could get rid of some of the sludge. But the point is instead of getting sludge take care of your engine get an oil change every 3000 miles you won't get any sludge. My car must be good because it has 175,000 MI. What I'm saying is if you know my car had sludge it probably wouldn't last 175,000 miles. But because I have a lot of miles that must tell me that my Toyota matrix was taken care of by me as an owner and the other people that owned it otherwise it wouldn't have last that long but that's just my opinion

Fill engine with diesel, set 1 day, drain

Please don't tell me that's a Dacia 1310.

مضبوط

عاش

just added the same oil turn on a while and drain again... the sludge will follow down with the new oil...

scrap that car

Better quote them an engine swap

Wash your car bro!

A very Creamy Goo

nutella??

How do I get headlights off

That is disgusting if you just change the oil on a regular basis your car last longer that's gross

Nice video but may not hold the camera with one hand, 10 dollar clamp would be safer, no?

Taycan 4S go home!

that engine is scrap metal no bg product deserves going in it it needs to be destroyed.

Dude learn to talk

When idiot testing 2t oil 😂😂😂

Did you need to eletronicly codify the new brakes?

Thanks for posting this. Now can someone prove that removing this device actually improves performance in any way?

DAMM BEAUTIFUL 😘😘

?????

merita banii varule ?

it need detergent and kerosin for more than 8 hours in hot wheather

Nice what did you get? 3.3 seconds?

I just put in an order for mine, cant wait to get it, is the heat powerful enough? I live in colder states, I blast the heat to maximum

Just like mother used to make

Better stayed speechless