Видео

@nazettos, I always find your video interesting. Question for you, after doing this nod, do you still hear the tire rotation sound when you roll down either of the two rear windows. That is very typical of all toyota. 👍

If the bulbs go out do you need to replace the whole unit you installed or is there a bulb you could replace?!!!

Thanks for posting! Hope to do this too some day

Good job. I also soundproofed my Rav4 with similar mats only a little thicker 2.5 mm and glued the plastic panels with soundproofing sponge 2mm. So far I have soundproofed the trunk and its sides , trunk lid and all the doors (inside and outside plating and sponge under the side) and the center pillars those by the belts. I still have to soundproof the hood and maybe next year the wheel arches from the outside. I can confirm that you will hear the difference in volume already after the first ride after soundproofing.

Worked perfectly. Thanks for the electronic brake procedures!

Thanx Mister. After researching this topic for a while I like the choice you made and how the video is made. I purchased the same speakers from Amazon and installed them and music sounds a lot better. Later on I plan to put pair of Focals in the front door.

U cost me money man! U need to say if u have the 12v on the clips other way around it takes out the piston !

There is a washer between the pcv valve and the block that you didn't put back in because you probably didn't realize it fell off while removing the valve....just sayin. That washer is there to fill the void between the block and the pcv valve.

I have the same exact problem with my car (VW ID4) , is there any solution? would disconnecting the car battery for 30 minutes solve the problem?

Love your tutorial videos! So helpful and informative!! Thank you! Keep up the great videos!!

As previously commented on, I was immediately concerned about Airbag danger in the A-Pillar (should have removed the A-Pillar cover and routed/secured the wire to ensure no Airbag deployment restrictions), as well as the noted rear window interference. I also question how secure the rear power wire is routed under the front windshield header....there is a ton of space between the header and the glass.....I bet the wire will fall back out and droop down in front of the glass. You pretty much have to remove the sun visor and A Pillar cover so you can drop down the header and then use gorilla duct tape to fix the cable on the backside of the header.....or shove it even deeper behind the header connection points to keep the cable from falling back out. Also worth noting is that tapping into the mirror power is fine, but will ONLY give your camera power while driving....You won't have any parking mode surveillance capabilities while the car is shut off and you are out of the vehicle. Other than that, you did a pretty good job of bringing this product to the attention of those looking for an integrated solution. If you only want a front facing camera, Dongar Technologies makes quick and simple mirror power adapters to work with virtually any dash cam. dongar.tech/

Wonderful tutorial, thanks!!!

As others have said, the hardest part is removing the lever on the side of the seat if you don’t know what you’re doing. You have to pull the circular cover off, then use a very thin screw driver or pick to move the clip inside the hole. This video gives you a better idea and also shows how to solve another issue that might be causing this problem: m.ruclips.net/video/IkYDjYWTosU/видео.html&pp=ygUbTWVyY2VkZXMgZ2wgcmVhciBzZWF0IHN0dWNr

With this unit..How to access the SERVICE MENU now?

With this unit..How to access the SERVICE MENU now

If I may ask, what was the OTD price? Thinking of buying one, your NX car is just awesome!

You should use a AGM battery. The flooded acid batteries are not as durable.

Do I have to disconnect my phone or no

Hey mate, taking delivery of my 2024 XSE very soon. Your videos are very helpful and well done. I will be upgrading the sound systems as you've done. thank you

Do the brake pads on each wheel of the Toyota RAV4 from 2019 to 2024 have inner and outer pads? thanks！

Most helpful video I’ve seen today. I did it in about 20 minutes! Thank you!!!!

THANK YOU

Thanks - just changed it by following your directions. Could not have been easier - really appreciate you posting this.

Did it made car quieter?

Thank you for your business! Awesome video!

Great step by step explanation for the install

Hi, very nice. I would like to buy one but I can not find one in my area. Thanks.

But how do you transport bikes on this car without a hitch

Great video, just used it to successfully change my rear brake pads! Thank you!!

Just installed this. I upgraded to a radio with wireless CarPlay and it’s so smooth that plugging in to charge became annoying. Thanks. 🙏🏼

I bought the same Camry new and kept it for 218,000 miles and 15 years. I took great care of it and the car was as dependable as any car can be. No issues and no leaks for 15 years. I never even had to service the AC!

Is it removable? Does the 3M adhesive stick permanently to the original trim causing damage?

I have a LMT'D V1 with over 4000 miles. If the V2 is half as much fun as mine, you're gonna love it.

Are you a rich guy? How do you find such a beautiful wife?

I hope you answer a question I have with my 2020 Camry 2.5 Dynamic Force engine. The engine has just under 21,000 miles. I bought the Phoenix Systems 8006-B Double Ended Coolant + Brake Fluid Test Strips. Both the coolant and brake fluid tested to be in excellent condition according to the strips. Do you recommend changing both fluids since the car will be 5 years old in February? Have you tried these strips? They are highly rated.

Is this model A or model B ? Of fitcamx ? You have to mention that

I would open the bleed fitting on the caliper before compressing the piston. This preserves the hydraulic piston and seals in the system.

Hi , is there any problems with steering wheel controls ? How much is that unit

very nice car, enjoy it

Great job

Screen size of any kind is measured diagonally Mr Nzar. Thanx for the video 👍

How you change the water valve to that model?

Just a quick question can you explain where the vent tube is on a 2010 venza with all wheel drive?

Great video. Thanks for the info!

Excellent video demonstration. Very detailed and explained it very well. Thank you and great job. I’m sure it’s not easy working and recording every step but you knocked it out of the park

That oil filter cap wrench is too wide on the outside. Get a short cap one.

Fantastic video! I have a 2020 Camry (bought new) with the same engine. The car has just under 21,000 miles but in Feb. I will have owned the car for 5 years. Your procedure exactly matches that from Car Care Nut. I wanted to see another video to make sure the procedure matches. I had some doubts regarding "turning off the AC, heater, and fan, everything." I come from the "old school" where you turn the heater on. I'm going to check the cost to use Toyota coolant and will compare the cost of Peak that you used. Thanks for the video.

This is the best video for this vehicles belt change by far

Tengo un Toyota venza 2013 4 cilindros y quiero hacerle el mismo trabajo ,es igual al q acabas de hacer

Your amazing, thank you for this 😎