Видео

@@deepakvishwakarma8945 bro hardware available nhi hai lakin jo bhi btaya hai shi btaya hai koi bhi step miss nhi hai

@@automationwithdeepak4628 bro logic bna liya but communication nahi ho raha

@@automationwithdeepak4628 aage jese communicate karne ke liye or kya process h iska

Go to the view and then go to the docking window and and then select element selection

@@Flyingwings. How

@@anjusandeep2566 go to the parameter setting and after that click on module information then right click on FX5-4DA-ADP module go to the resister to intelligent Function module monitor

@@muhammadshehbaz7765 thank you so much

Use individuals for every HMI

Ok bro

Frequency write ke liye bhi maine instructions use Kiya hai

Not same

@@automationwithdeepak4628 OK

This video I explained complete process

Please explain in detail

Thank you

Bhai x0 is module healthy status .X0 is permanent on when module is healthy condition

YC is auto communication bit.

So when module is healthy state we can on YC through x0

@@automationwithdeepak4628 if it is not in healthy stated them, what should I do, Right now my module showing error , And ab me Yc and y8 on krta hu to error bit on ho rhi he and it is saying that first stop the communication and then start YC. But it is not seting up communication, modscan se check kiya he drive se data aarha he but yha setup nhi ho rha he

What is Start io address module

deepak821800@gmail.com

@@automationwithdeepak4628 OK Sir

Ok I will make a video on this topic

Yes

Then in that case, what should be the steps, how should I need to put the data register Should I start it with D..... OR DIRECTLY add data register number

I would recommend you to please make vedio on schneider vfd communication with FX-5U plc

Next video comming tomorrow

Aap ne achha explain kiya hai

@@pushpendrasingh-se6kn Thank you bro

Follow the video I am sure you make communication easily.

@@automationwithdeepak4628 when I try to download the program to the PLC it says that it won't download because my PLC (FX5U-32M) is not compatible with simple communication. I have seen in other tutorials that I must select active communication instead of Modbus tcp in module configuration. After that, supposedly I need to add TCP protocol in online>predefined protocol When that is added, the TCP asks me to add the specific read or write command number for communication (1,3,6,16 etc) When that is done, I need to configure which devices (D#) are going to be read for the Modbus TCP communication (Id number, head register, number of registers to read) Finally, the ladder logic, I think the command is sccom or something like that I can't try all of this because until Monday I go back to the office, but if you have the PLCs at hand and if you can try it, please tell me if it worked

I don't understand why, but it seems some people configure just the protocol, others use simple communication, others configure the protocol AND choose the active module. I must be doing something wrong because it should not be that difficult I mostly use Siemens, my Mitsubishi PLC is brand new out of the box, but as I told before, the list of connection does not display Modbus TCP, only "melsec/ iQ communication" and when downloading an error occurs that says that my PLC does not support simple communication, and if I force it the PLC shows error Status Please see attached video ruclips.net/video/urEttsQ_k8c/видео.htmlsi=JU9m7QqqXaygAQEm