- Видео 1
- Просмотров 74 159
Emsc Palm
Добавлен 26 июл 2017
2003 Toyota 4runner VSC Trak Light recalibration yaw rate sensor
Reset your Yaw Rate sensor if VSC Trak lights on.... especially with a 2003 ..if you have a check engine light diagnosed it is likely to wipe out the computer memory for the VSC and you have to reset it...
Просмотров: 74 163
Thanks!
Who takes their car to a muffler shop for the check engine light?
Just did it!! Thank you so much! Everyone saying replace gas cap. But I never had a check engine light. Phew thanks again
Nice job. Other videos didn’t tell you to have the wires touch each other and turn it on at the end otherwise it won’t work.
effin brilliant
So will this work without replacing the Yaw sensor or is this Only to calibrate a new one?
Will this work on 03 Highlander
oh my goodness Had work done on suv replaced 2 o2 sensors, big bucks., and still lights were on.. i'm guessing now that it over and done with& spending $200plus & this video I didn't need o2 sensors. Just needed reset yaw rate sensor . .A BIG THANK YOU
so will yaw rate malfunction code trigger/affect the ABS as well? the thing with Yotas are once the check light comes on it disables a few things like -VSC TRK light come on like. Christmas tree
Abs is not on when this happens. That's kinda how I knew it was a simple calibration problem because it was only 2 lights on but not ABS
thank you!!!
Great video, easy to understand, had these freaking light on for two years and now they're gone thank you thank you thank you
You talk too much. What's wrong with getting straight to the point?
Damn im having this issue. Looks like im off to Lowes to Jerry Rig some copper wire tool
some times dealer ships don't know what they re doing 4.7 4runner 2003, next issue you will have is the abs pump motor under the abs unit, if you start to hear a noise screaming from this little black motor, don't wait until you loose your brakes totally, like I did, you could get on a serious accident. 4runner 4.7 2003 great car!,
is that the noise you here on start up like a humming or buzzing type then it stops after 5 or 10 seconds is that a normal time to here it or is it a diffreent noise i have a 2001 4runner
Having that problem now I replaced the elec motor on it worked good for a week now the abs an break light is on but it still brakes fine but now im stuck with that stupid abs alarm noise
@@jessehern91 dont waste money buyin a used one, you sould buy a new motor www.ebay.com/usr/wholesalepartsexpress02?_trksid=p2047675.l2559
Did the scanner give you a p0420? Code
C1336 ... i just had p0420 which is bank1 or bank2 cats. i replaced both my exhaust manifolds
Great video!!!
you save my life!