Видео

🙏

sir in video part 2 constuction of 60 deg cf is 30mm u took 25mm please reply

🙏

21:06 y u multiplying the 1.54 again

T=99750Nmm ✅ T=99.75Nm ✅ T=99.75Nmm ❌

Playlist name of this video

time waste

Thank you sir

Sir clcok wise -ve anticlock wise +ve

Thank you so much sir very good explanation because I watched more videos earlier but I didn't get any clarity from earlier videos when I watched your video I got full clarity once again thank you sir

WHICH IS NOTHING BUT...

Honestly the clearest and most concise explanation I have come across. Thank you!

Please, provide the name and author of the you have used to prepare this lecture .

Thank you sir...🙏

Sir's handwriting is op . If write in that handwriting I will get full marks 😂

why multiplied by 10 and not 100 , its suppose to be 660 ig

Its rockwell hardness then how to tell unit bhn????

i am not satisfied

how did you find h value , but the h line has the orgine of A line but you draw perpendicuer , that is inclined in book answer

Well Explained 🤩

❤thank you so much sirr i was stressed about graphical method frrr

Thanks a lot sir this helped me a lot

Thank you sir

⭐

Easy ko hard banana koi apse sikhe🙏

What if we have 0 in graph how to take months

Thankuu sir

Sir if downward is negative then Tangential stress should be -15N/mm2

Solution on determination of firing order analytically

Пусть так решит для для количества 20 и 60, тут и так все очень просто.

Thanks

Sir How u got 500,1400,1000

far away to see

The answer of torque was first found in cm and then convert to meter right?

❤❤❤❤❤❤❤

sir please make videos on tom

F34 should be equal to 5250 N, not 1050 N.

❤

🔥

Sir please mention the question in the beginning, how will we know what we're looking for?

Thank you 🙏

Legendry

Sir notes send kijiye

Why 140 degree is set for charpy test?

What is your address ?

Thanktou sir u vedio's are always helpful 🙏

For finding couple @d right why we are not consider coulpe at @d

Sir aapko pata hai padhana bhi hota kaise hua kyu hua kya rule hai sirf khud solve nahi karna hota abhi sir dukhra mera ye video dekhne ke baad

Hi sir, good evening! I have a doubt. In my question the angles were changed crank angle =45degrees, 135 degrees, 270 degrees and 315degrees. offset distance is 12.7mm. OB=50.8mm, BC=101.6mm and magnitude of force is 200N. what steps should i follow in angles? Please do reply.

Sir nice teach useful to my studies your video sir😊