Видео

Love it man, great video thanks 👍

I saw a video where the guy said it’s the temperature control unit. Because the harness from the sending unit and cluster meets up to the unit and there’s a short in the unit.

I went thru over a year of problems with my Altima and this. Replaced the fuel pump twice. Ran out of gas a couple times, had to pay for towing etc. The problem with these Nissans is always the instrument cluster! They’re not hard to remove, then just send it to an online place that repairs them. The tiny soldiering joints go bad and cause the fuel gauge to not work. This in turn causes a CHECK ENGINE LIGHT because without the gas gauge working correctly the computer can’t do an EVAP cycle check causing a code 0420 which can fail your state inspection. Trust me, it’s the problem.

So helpful!!!! Take a walk😂! Life lessons for conflict resolution too😂😂😂👍🙏

Right what I needed. Thanks hoss!

No mame viejo está peor q yo para ablar mejor able español se le va entender mejor

What did you put on thing to get you put the whole fuel pressure regulator on there or did you just put a small part on there that's the part I did not understand because you did not mention it what did you change you just said you have two parts coming

Thank you for showing this helpful RUclips. It made my job a lot easier.

Mucha platica🤣🤣

What tool did you use to get that bolt off that’s in the deeper part?

Once again, awesome sir, you rock

Awesome, video brother I have a 97. Also keep the videos coming.

I replaced my dash cluster which I have bought out of a junkyard and the P0462 code went away for over a year and then the code came back up

Thank you sir that was super helpful

what's the name of that piece? for the fusebox

Amen, keep preaching my friend! Very dumb idead to ride without gear!

How long before the fuel pump goes bad?

great video!

Great video. I was able to get the job done easily. Thank you so much

do you recall what code you got? what was the part # that you did replace?

Ford has a user accessible "Parking Brake service mode" that makes this completely unnecessary. With ignition off, simply hold throttle pedal down while also holding parking brake switch off and cycle the ignition on and off slowly 3 or 4 times. On last cycle, you'll hear parking brake motor and the dash will show a message for "parking brake service mode." From there, changing pads is a breeze using the same caliper tool used in this video, no need to remove parking brake mechanism. To exit the service mode, you repeat the above steps except while holding the parking brake switch ON instead of OFF.

I finally tried it and man it works exactly how you said it would!!!!!! Thank you🎉

Thanks for the tip. Definitely will try it today!!

this was exactly what i needed. thanks!

Religious experience going on here

You deserve an award

Great video and worked perfect and thank you so much for sharing. I hope more people find it.

Worked like a charm

saLom

This is great info, thank you for the video.

Where to buy and how much

You're right, you don't know.

Papu - mine has two misfires as well, but the harness runs left of the tank and doesn't seem to have any damage. Did you find anything else with the wiring? It only happens when the throttle goes above 2k rpm, then it shakes real bad and has misfires on 1 possibly 2, any ideas? I changed the spark plugs and the throttle sensor/pedal sensor. Since those are notorious on this car. Any tips would be appreciated!

Good video. In my case , I have to take that electronic parking thing off anyways, because I will be replacing rear calipers however my question is ,if someone was not to change calipers , do they really need to take that off and use wrench to loosen ,if they have followed the procedure to disengage electronic parking brake in the vehicle prior to changing brake pads?

Please,my fuel gauge is not working and I need replacement,where can I get some to buy

any chance you could tell me the color scheme from top to bottom?

How difficult is it to change the sensor...

Was this a coupe si or sedan si?

Wish I watched your video before dismantling everything else! Even without cutting the boot, just sliding it down, I was able to see & repair the severed wires. Thanks for sharing. 🤙🏼

Great video!!!

if you do this and it works foes the check engine light turn off or do you have to clear it somehow?? thank you for any replies

I'm at about 17,000km on mine and now it is time to replace but they still feel good, can't wait to try gt2's

If the fuel pressure is bad would the car start

I tried this but It didnt worked I also replace the fuel pump assembly but it still dientes work

Thank you

Thanks man!❤

Quit guessing ok it’s the rings burnt

Oil burner

Did u have to drain the oil before I changed the filter or can u just change the filter without draining the oil?

Muchas gracias.