Видео

This is the process I used to raise the deep shaft outboard higher above the existing transom level. As well as add extra strength & rigidity to the stern. I hope this help you determine if this process is applicable in your situation. Those are old shock absorber bushings & I used Sikaflex caulking around the back plates in contact with aluminum & around bolt holes & edges. So far this past ye...

Take a boat ride up the Potomac river, under the bridges & past the monuments to the Kennedy Center all while planes fly overhead landing at Regan Airport.

Time lapse from most of the Anacostia river to Navy yard entrance of the Potomac River Sea sickness warning !! varying speeds Join me on this 1 hr journey compacted into less than 3min.

View from Potomac waterfront at Georgetown tie up

Freshwater river run on 12ft 15hp aluminum boat. First solo speed runs on shallow river. Trip to main river you'll know the area if you recognize the sites. Around 18 miles total split into clips of down river & up river. Custom riser transom support with 15hp Mercury Sea Pro long shaft -20". Red split cut coffee can on backside of motor mount is to redirect water that was spraying too close & ...

2 Person speed run, boat wake on raised transom with 15hp Merc Sea Pro deep shaft on 12' aluminum boat. Original transom height was 15" for short shafts. New strengthened transom is reinforced & raised to allow for 20" deep shaft & lower draft. Nearly in line with cavitation plate.