Видео

original post found at: solidsanity.com/?p=1107 Notable Points: 1:05 Description of starting sketch 1:44 Extruded surface 2:20 Driving sketch for side curvature 3:54 Project sketch using split line 4:40 Delete face 4:55 Ruled Surface 5:58 Boundary Surface 7:17 Selection Manager 7:38 End constraints 9:18 Discussion on why this is a good way to model 10:45 Boundary surface (2 directions) 11:40 Mo...

Visit: gosimulation.com/ for full file set. In this video, I’ll clean up the joint groups, apply more realistic materials to the beams and apply a more realistic load. The purpose of this simulation is to locate areas within the model to focus our efforts for subsequent simulations. Notable Points: 0:00 Introduction 1:06 Creating the Walk Simulation 2:18 Editing Joint Groups 8:25 Materials Disc...

gosimulation.com/ *This is an advanced tutorial. It is recommended that you have experience with beam elements within SolidWorks Simulation before beginning. In this video, we’ll explore a little known FEA workflow called the Crawl Walk Run system. The purpose of the Crawl Walk Run system is to get accurate simulation results from very complicated models. Notable Points: 0:14 Overview of the Cr...

Please visit gosimulation.com/ to download the part seen in this video. In this video, we'll learn SolidWorks Simulation in under 11 minutes. To do this, we will simulate a linkage arm being pulled with a force of 500 lbs. This linkage arm will eventually be manufactured through a casting process. With this said, our goal will be to vary the geometry of the linkage arm to reduce the volume of a...

In this video, we will create a non linear dynamic simulation with SolidWorks Simulation. In this simulation, we will study the effects of two components traveling through space and then coming into contact with one another. We will explore time steps, fixtures, initial velocities and damping. Finally, we will measure the contact force with time.

Visit gosimulation.com/ The five best SolidWorks selection tools: split line, filter toolbar, select other, invert selection, and the select tangency. In this video: We will explore the five six best SolidWorks selection tools. These tools have saved me a lot of time (especially when working with SolidWorks Simulation). We will cover the split line command, the filter toolbar, the select other ...

gosimulation.com/ Gosimulation is the only online resource which is 100% devoted to SolidWorks Simulation training. Originally posted at: gosimulation.com/mohr-coulomb/ In this video: We will learn how to work with brittle materials using SolidWorks Simulation by simulating the effects of a person sitting on a granite bench. We will learn about how the Mohr Coulomb failure criterion is generall...