- Видео 5
- Просмотров 74 306
DIY Slen
Добавлен 6 июл 2020
Halloween window decoration (Part1)
Helloooo...
Requirements:
12v LED strip
5mm RGB LED
Male Female DC connectors
Soldering Iron
Hot Glue Gun
Insulation tape
Note: This video is for educational purpose only.
Requirements:
12v LED strip
5mm RGB LED
Male Female DC connectors
Soldering Iron
Hot Glue Gun
Insulation tape
Note: This video is for educational purpose only.
Просмотров: 29
Видео
Halloween window Hack
Просмотров 343 года назад
Hi everyone, just came up with a quick hallowe’en hack.. more coming in next videos. Requirements: 5mm RGB LED(Clear) 100ohm Resistor 18650 with charge protection board A Switch Hot glue gun Led bulb cap(optional) Note: This video is for educational purpose only. It could be fatel if unsupervised. Be safe. Thank you
How to fix PXE-E61 Media test failure PXE-M0F Media test failure
Просмотров 54 тыс.3 года назад
Hello everyone I have been trough all the videos on youtube how to fix this problem on Laptop Acer Aspire 5742 Series. Step 1 : First reset the BIOS by taking the BIOS battery out. Step 2: Clean the hard disk connections on the motherboard. Step 3: Install Windows 10 or higher version if your laptop sustains it. Hopefully this will resolve the issue.
Remington HC365 Battery Replacement
Просмотров 21 тыс.4 года назад
Please be careful while replacing the battery. Always check the compatibility of the replacament battery and make sure to check the polarity before installing. Thank you.
I found what I was looking for. That hidden screw was misleading me to open a body. Well done mate!!
😊😊
Spot on , thank you.I think I will use glue solder (no heat) to re attach the wires.
I dont think its worth to replace batterys . Cost of them its half of the price of the shaver .
Can you please write the Battery Type and Voltage?
That's what I am looking for. Thank you for sharing. God bless you😀
Thank you
I tried installing windows 10 and it didn't work
Tnx u
Bro I already have win10 so what I do now
Thanks fella, well done!
Please what is the short cup 😭
Thanks alot
Nice tutorial! No need to remove the silver casing, after unscrewing the bottom, the rest will pop off with a pry tool!!
Thank you! I think I'll cut out some space for a battery basket and secure it with acrylic glue. This way I will avoid soldering batteries which could be tricky.
I didn’t see what you where pressing
Thank you. That is such a help !
В моем случае этот способ не помог!!! Виндовс 10 установился на мой старенький ноутбук, но сама рперационная система не загружается((( Ошибка повторяется. При этом сам жесткий диск БИОС определяет. Программами тестировала, плохих секторов не гаходит. Опасаюсь, что дело в плате (может быть даже в материнке) или в шине питающей жесткий диск! Эх...
I’m was fixing and replacing the cables on my old pc and I might need to get windows 11 on a stick to fix the issue as windows 10 messed up bad from my upgrade from 7
The resistor closest to the red LED on my hc-365 is burnt out but I cannot see the colour-coding from your video to replace it. It is black all over on mine. Can you reply to this message with the specification for that resistor please?
Dhoondla araha ha
Dang that a big motor.Should of replace it with Li-on batteries and around 1000 mAh higher with the same voltage the battery and the device will works fine.Than your shaver can lasted it to more uses and another year longer without needed to replacing batteries again.
Useless video
did this but after screwing the blade back-it doesnt cut hair anymore? (motor works fine....)
It works for my Alienware. Thanks bro 👍👍👍
In India??
How can I get the blades and charger for this hc365
Thank you!!
Bro komp filesi is deleted?
Excellent instructions
is not working for me
Hi bro can your help me
Nasir Khan Hello, how may I help?
@@Marioisgamer help me bro its still not fixed
World Mania hi, could you tell me briefly step by step how you went through?
ruclips.net/video/MgusL65pRLk/видео.html help
Also, have you a video showing the soldiering the new batteries in as it seems tight for space many thanks
can I just confirm with you, you say the battery is 1.2V but when I go online the twin batteries are quoted as 2.4V which makes sense if the batteries are run in series. So, the combined power is 2.4V not 1.2V would you be so kind to confirm. Any many thanks for posting the video
Hello Hugs, i will be uploading a video on the installation of the batteries and their connections. The batteries are 1.2v connected in series.
@@diyslen200 thank you very much xx
Nice one! Loving the videos. You should think about using smzeus . c o m!!! I’ve been using it to help grow my Instagram, you could use it to promote your channel.
Thanks for your video, another item I've saved from land fill!
Thank you mate. I was able to fix the problem
That's what I am looking for. Thank you for sharing. God bless
Thanks! Was looking for this everywhere!