Видео

1 Battery 6S is possible fly?

Hola por favor me podría decir como van las conexiones de la controladora

Do you still fly the engine ?

That’s what happened to mine but there’s just a huge ball of fire

same with my 3s what to do

Check the servo frequency. If it's too high it will work on the bench but burn up when flying.

Hello friend from Puerto Rico where I can get the engine Rotor Star 56 Hyper or GH-56G gasoline Heli by favor if you save where you can send me the address thank you friend.

Same problem here. Thought it was defective servo, wasted another 30$. It's only front back tilting pitch roll are fine. Does the same thing in the air.

i had same problem

can this be purchased in the US?

Please give us some part numbers XXXXXX so we get the right module .... hobbit King will sells a lot of these modules :( Thank for the info . beware

What is the part number of the hobbie king module you used ??? ... I got a #9171000302-0 sent to me and it will not work with a Turnigy 9x so ne careful what you order ... the Hobbie king page said it would work ? back of the box says JR / standard ?? i like to send it back but hobbie kind will not return it ?

did you happen to fix this?

That's some really sweet flying and that Assault 700 sounds great! I see in the description that you're using a beastx...very cool! Would you mind sharing the other electronics that you are using (servos, motor, esc, batteries)? I've recently been given an Assault 700 kit and I'm shopping for parts for the build.

which parts have changed ?

all stock??

can u tell what range do u have on this module with turnigy9x? 200, 500 or 1000 meteres? thx

You did a good job !

courage presque ^^

Nice flying

You may want to change the motor pinion gear to 13T.

i said i have a trex 459 clone so its not FBL but the tail pitch slider its maxed out but i think i just had the atv setting to low but thanks i have yet to try it though

Hi, yo90bosses, I would suggest to check for the endpoints in the tail pitch. I have experienced where end of the tail pitch is not fully extend when max rudder input is given. After adjusting endpoint in the FBL gyro, the tail will piro faster. Take note of the binding too if extended too much to touch the ends of the tail. Both ends are extended such that it will have about 0.5mm gap between the tail pitch slider and both end. Transmitter endpoints are 100%, with no expo and 100% dual rate.

ive got a trex 450 clone with a 3550 kv motor 3cell lipo and a 10t pinion and it piros WAY slower than yours any suggestions to make it piro faster?