Видео

I have the 2002 Odyssey and is it is the dumbest design to not have a inside rear latch handle. my kids cannot open it or the windows for fresh air. There is only two side vent windows that open only one inch and only the driver can open them. How does this pass the inspections of the American transportation department add safety for children.? The sliding doors are nothing but a hassle and problems and issues and the alarm is going off so many times I had to unplug the horn.

Thanks for posting; I tried it and it worked!

Where is the video on how to put the replacement door on?

Thank you very much for your video, it was a great help. My radio lights were dim to none and after following your video they are just like new again!!

very good way to fix that, but my problem is mine will not close all the way so my van is forced to stay unlocked until I can get it latched

good video! Is there a way to "turn off" the "changing radio color display" on a 2007 Ford Fusion? It's distracting.

Hi Great video. I have a 2002 Explorer Ford radio/CD. THe radio keeps jumping into Seek and only stays on my chosen station for a few minutes, then it Seeks. What can I do, please?

Great vid. Quick question would you happen to know if these are T3 & T4 bulbs if so how many do I need of each and which will it cover for each button. Thanks.

How do you manually lock the back hatch when the battery is removed?

People like you make the world go round

Thanks!

Used paper opener now the cd is spinning what next

What causes it to spin when no cd is in

What year fusion is this

Awesome! This really worked out well!!

It worked! thank you!

Thank you so much. This worked.

I don't have a aux on my 2006 Ford fusion se

wheres the trans oil? Did you have to drain the lines first ?

Thank you!

U don't explain anything I don't kno what ur doing size of tool and where the connections r

My Dad just bought a 2006 Mercury Milan and the radio was working but nothing on the display. Found your video and after a quick trip to Walmart for a soldering iron and a little bit of a burn from the soldering iron I'm pretty sure I saved my folks a few hundred bucks on a radio. Thank you for the video! Absolutely spot on!!

Thanks man

I just noticed mine leaking at the bottom connection around the hose clamp area. Would the car be safe to drive 15 miles to the mechanics garage?

I have a 2009 MKZ which is the same as the Fusion and Milan, to date I've replaced the trans cooler lines twice due to rusting through. I've tried to reach the lower radiator cooling line without removing the fan shroud but I can't get to the fitting. I did like this person did and remove the shroud, only takes a couple of minutes to get it out and makes the job a whole lot easier. Leave it to Ford to put the cooler lines along the bottom of the radiator where they get hit with road salt and other garbage. Next problem is the water pump *BEFORE* is starts to leak. Another great Ford idea.

so how do you get these out to replace them is just as important

Worked for me for the radio on my 2011 F-350. Thanks.

Do you know if the 2009 v6 Fusion radiator,condenser and fan is them same as the 4 cylinder fusion ?

Thanks, this helped me replace my window regulator.

Thanks for posting this it worked to release the latch and open the hatch. I struggled with it a little by just trying to pull up on the back mechanism. What made it open is getting some momentum going by repeatedly pulling up and letting go to gain a little velocity and momentum, then one of the up strokes popped the hatch open. Thanks again

How much would a replacement cost ? With parts and labor ?

I hope to see this again in 2021!

I concerned I don't have the lines all the way connected to the radiator. There's like 2 threads exposed and it's tight, I have taken them off wiggled pushed and everything else and I can't seem to get it any tighter? Am I missing something, or.

the lines are 16mm, you don't need to take out the fan, you can reach the bottom trans line from the bottom finger tight it in, than go on top reach down in with a 16mm wrench and tighten the bottom trans line.

Do you know the depth of the assembly? Is it possible to trim the front? So the fan can get closer to the radiator, even if just a bit? Thanks.

I repaired it, Thanks a lot

Amazing

Currently doing this and the ac condenser the lines weren’t that bad after removing the fan but man that condenser sucks to take out

It’s work, thank you so much Nov 29,2020

Mine won't take a CD! Says CD error when it's initializes. Won't take a cd very dumb

I've had my 2006 Fusion for 12 years and the display has been out completely for about 8 years. It would occasionally come back if it was really cold (0 F) and you gave it thump. After awhile even that stopped working and just dealt with it. After following the guidelines in your video I was able to restore the display. Thank you so much. Had similar problems on an 2 Escorts, what is the deal Ford? Over 110k views for this video tells me this is a design flaw/QC issue.

How did you manage to wrestle the upper line around the rock solid wire harness? Seems impossible.

🤩

My radio is very dim i think this is the right video

Thanks for making this, it helped. I'm about to do this job tonight

Here I am researching to fix my girlfriends car and your handle is Stimpy's Stud Service, which I didn't realize was a Lego reference until I saw 'Lego Creations'! Very awesome, I could fill a bathtub several times with Legos! Awesome!

Yo stimpyyyyyy

2:40 “are you warm enough? Ok.” Lol

I'm ready to tell a MF MECHANIC ILL CLEAN YOUR HOUSE AND CUT YOUR GRASS FOR THIS JOB WHIC WAS QUOTED AT 495... WHY IS YOUR TIME SO MUCH MORE IMPORTANT? AND THATS A BLOWOUT. SICK ABOUT THE MAKEUP

I just installed a radio into my 2007 Ford Fusion and the steep works fine but now my battery light and engine light is on , do you think I installed it wrong?