Видео

Looks good for my phone...!

What happens if theres a leak down the road?

Saw the electric heater but no drain on that line.

Why reduce to 1.5 then back to 2 again

Is that a domestic expansion tank on the heating system?

suffolk, ny

This is good, at least 6"to 10 "above the sub floor no nails or screws below 6"

I like the idea. But questions about this system. What happens in the event that somewhere in the pipe tubes leaks a hole or gets busted. What are the implications of repair done? Would be as easy as removing a section of the tube? Or does it require to replace the whole band of tubes ?

Does it get regular heating to of some sort ? Radiator, boiler , heat pump, etc ? Curious if jus that alone is eniguh to keeep the house warm and keep it from freezing the pipes

Where’s the filter? Looks good

What material did you use?

Does the liner need to be installed if its on concrete slab? (First floor)

What do you do after that?

When you’re pushing into the corners with the screwdriver are you not worried about damaging the membrane ?

Do you pour your motar with the slope prior to that in the wood subfloor or you do you just put the plastic straight on the plywood

Q pegamento usas Para unirlo? gracias

????? Se ve bien

Cuál es el costo de ese trabajo

No drip leg bro?

Piping is on point but that white box in the middle that says navien on it 🤮 im so sick of getting service calls for those and running into cross contamination.

I have a 1500 sq ft 1st floor - 1 master bed + bath, 2 smaller bed rooms, 1 small bath and a large loft. Currently, it is served by an aging gas furnace + AC. The return is one single grill in the hall way. Master Bed and loft has two supply registers and rest are one register each. My guess is that I will need 36K BTU heat pump for this. Can one or two such slim duct Fujitsu serve this floor ? Since the opening to attic is too small ( attic itself is big ) to take up a full size air handler, I am considering this slim duct option . Another constraint is that only vertical mount option is feasible for supply registers in master bed and loft, as the roof is slanting cathedral type with no attic space there. Attic is available for rest of the rooms , bath and hallway. I guess these slim duct AH can be vertically mounted too .

So after that your gonna pour concrete?

It looks like someone unleashed a metalic monster in that customers attic🤣

what was the TOTAL cost of the system install including cost of equipment,, the grand total?

Where is the navi clean or the magna clean on the return side for the cast iron on the hydronic piping