Видео

We've tried to find this a few times but haven't had any luck. Can you help us out? We would be leaving from Big Earls campground.

This is the best way to do it and get all the trash out of it, Thanks 🙏

I tried rachet-straps and rope to no avail. This worked great! On my 2nd rear wheel, I tried using a milk crate for more depth. It worked great as well. Cheers! 🍻👍🏼

Good luck 👍

how much did you put back in i can't fine no Data on it

Where is this

Great video. Would love to tag along and find out where these trails are sometime!

I bought a used harness and I still have this code. Tried this with my old harness wasn't the problem. Now it get to check the used harness. You think that's a pain try replacing the harness.

What the?

Is axle removal the only way to change the oil? To bad there's no drain plug on the bottom.

Wanted to know when transmission on jeez

Do you have a link for where the pumps can be purchased?

thanks for the info! Did you remove the engine to replace the bearing?

Good work, I do it the same way except I use a second person to inflate while I push the rim. Also I leave the tire stem core out until the tire bead is seated. You get more air flow to seat the bead. Then I put the stem in for final inflation.

Well done Greg and thanks from Adelaide in South Australia. Before your video we stuffed around for at least 3 hours. Thanks again. From Bill C

Nice bike

Looks like the Indian moon lander

What county used to hunt in webster

Where is this tunnel? I ride in the Julian and east Lynn areas a lot and have never seen this. Can you tell me where exactly it is?

I’m confused, I thought Perry had a width of 62” ? Is that not the case anymore!?

You're a genius

Worked great! Thanks for tip

wow the scenery here is beautiful!

Take it out of low gear!

Sweet trails! Hopefully i will be able to experience that in this lifetime haha

I have a 2012 wildcat and it slips out of high when cruising

So why did you change that bearing?

Where is the rest of the video?

Seems like good way. And instead of using some fancy method to break the bead I used my 10lb sledgehammer. 2-3 hits on each bead broke it

Been looking for a place go riding on the weekends would this be a good place to go

Your lighting sux video engineer

Can you get through the gates in a krx?

Run some hot water over them first or let them sit on top of yer engine for a few minutes, slide right on.

Are you from the area?

Can you take that assembly off without draining the hot tub?

I have the same transaxle. I was thinking about drill and tap a 1/4" drain plug to simplify. Whats your thoughts? I really enjoyed watching the 2 videos, I think they will help me save some time. Please tell me your thinking about a drain plug

I just did it as well ..... It worked....only took a few tries

Mine have all lasted from 1-2 years… you just need to replace the filter once a month 😁

Never seen it that easy👀

Can you give me a road name that the outlaw trails start from near Cabwaylingo?

Where’s this at?

Can you get to the tunnel from Delbarton in the buggies, using roads, which would include riding on highway 119 for 1/2 mile is that ok ?

What kind of transmission fluid did you put in? I see Mobil 1, but what specifically?

Pump kits are now unavailable on their website 😮

How is the heat and noise in the cab? I heard it gets HOT! Thinking about buying a KRX. Love your videos

Keep it up!!! Get the following you deserve > "Promosm"!!!

My 700 ran out of gas…put some in now wont crank

Good stuff thanks we ride Dunlow

Looks like you guys might be over there in barnesheave Down River Road and take that all the way over to Williamson

Where the hell you guys at back there on Peters fork mountain and then the playground or you on ballpark Mountain where you at Johns Creek stop over or what