Видео

You made that way harder than it needed to be

Very helpful!

Hey man, great video, super helpful. I'm just going to add one thing in case anybody else watching runs into the issue I did. When I pulled out my old window glass, there were two plastic brackets glued onto the bottom of the window. I wasted a bunch of time and energy getting them off the old glass before I realized the replacement glass I had was taller than what I took out. So it didn't need those plastic brackets, they were just there for the part you loosen up to grab onto. So at some point Ford must have changed the design slightly, made the window glass just slightly smaller and added those brackets. Once I realized that, I just put the new glass in and it worked perfectly.

What if I put in a used transmission that looks like it’s got a decent clutch

Can I just replace the actuators without inserting the ford tool and rotating the gears back and forth?

The part you replaced on the focus is that an automatic transmission output shaft speed sensor? I'm having poor acceleration and high rpms at 2500 1st, 2nd and 3rd gear after 35mph it drives fine, I ordered both actuators and new transmission fluid but I haven't ordered the speed sensor, can you please tell me if that's a automatic transmission output shaft speed sensor?

Can a faulty speed sensor still cause shifting problems on a 2014 focus ?

WHAT ABOUT IT SAYING TRANSMISSION DEFAULT SERVICE NOW

Oooooof

Did you replace any components? Gaskets, etc?

Do you have to remove the whole cv axle just to replace the outter boot?

Make sure you didn't cross 2 of the wires I've done that and it would run good on land but not water it's really easy to do

I watched and learned alot from all your videos much appreciated brotherman

On my 2006 2500 HD, I backed out the shock bolt and removed the sway bar link to get shaft out. Still much cheaper than replacing entire shaft.

Hey, two days ago I damaged a tire by hitting a curb and had to replace it. After the replacement, everything seemed normal-no warning lights or codes. However, when I powered it on again, I got a red “transmission damaged. Immediate service” message. The only unusual thing is that it shifts at very high RPMs (3500-4000) instead of the usual 2000. I’m not sure if the tire hit caused this or if it's just a coincidence with the transmission. It's a 2014 Ford Focus Titanium automatic with only 50,000 km. What do you suggest? Also, I need to change the motor oil.

Great video

Thank you man

Great video just had to swap mine out. I used a magnetic gun holder to keep window propped up worked great!

Great video!

Man your good. Very intelligent. Thank you 😊

Where the link

Thank you brother, watching ur channel really helped me get thru the parts of this Job I was having issues with. Ur video doing ur brakes in the heat, sweaty AF, is like me down in FL. Very informative! best I cld find!!

Thank you

Did your AC ever have any issues when the power steering fluid leaked? Since the AC and power steering condenser are together? I just started having AC issues but have had dripping Power steering and it is from condeser.

Car come from arkansas?

Time to go tap😂😂😂

Oh brother that’s a chuckle I definitely needed thank you.

Thank you .

Well that's not good AT ALL.

Ohhhhhhh boy. That’s a big one. Did you have to Drill n tap or are you magic?

It was all of them, wansn't it?

how do you use a hammer for that??

When a 2-3 hour job turns into a multi-day job.

Is this really how its done? The instructions show the other location where people find the bolts are too short, which obviously makes no sense. I would think that supreme suspensions would not supply too short bolts.

Where is the link to get the part located ?

May i ask were you ordered from ?

Can’t believe I bought 2014 ford focus for $4000 in nice blue with clean interior 128973 miles with a shitty transmission I’m so stupid

Thanks for the video, I had a 1980 camaro I was working on had one of the metal fuel lines leaking under the passenger door and I was able to find the feed line quickly and stop it before it became a problem thanks to you!

2012 focus. Have lost all gears. Shall I swap out actuators or go straight on to replace TCM? New Zealand is not providing any recall service.

I got my truck back this mrng. 09 Gmc sierra 15004wd, So the culprit to all my truck running like shit probs. D//S caliber locking up. Mech. was gna give back said was all fine ystrday. he drove again this am like I told him, said felt like dragging an anchor, There ya Go! 500° D/S 168° P/S. $900 To fix, picked up gna do myself for $100 or so. caliper, Brake hose.

As you can see Im new to channel. Bcuz of my truck I found ur videos! Brother Im hooked! If there was 1 tool I wish I cld afford, The impact cordless. I keep seeing it. Ripping my 35s off kills me, only 48 but Fd' up Back. Very informative hub work!

09 Gmc sierra 1500 4wd Z71 5.3. These Trucks are Junk. 2 brand new Trannys. 4yrs. 100k 3yr warranty. 1st lasted less then 10k, 2nd has less 2k. I miss my 79 Bronco, 78 K5 Blazer. Dont make em like they used too!!

Hey brother, I have 09 Gmc sierra 5.3 bn having issues while driving. voltage drops to arnd 12v nd truck hesitates. loss of power. 3 months like this, no CE light til ystrday after pulling boat. new batt. today, same issue. At a loss. Dis/Veteran (USMC), not a lot of $ to keep throwing at each month. Any ideas wld be greatly apprectd. Awesome Videos!!

Is hard to change the water pump?

Hey thank you my guy, this is the most accurate video I could find for my 2014 ford focus se. I’m having the same problem as far as my car going completely dead. I was told it could be a starter but I figured it could possibly be battery first since the car completely goes black. So now my first step is a brand new battery, recent it stopped going in reverse and doesn’t accelerate in drive. Any additional advice

Someone smashed my window, this video gives me the courage to replace it myself. Thanks, ill let you know how it goes!

Thanks for checking out the wipes!

My gas gauge doesn't work on my 88 yj either. Getting ready to fire it up after about 5 years. Cheers brother. 😁

So does the bass on the factory touch screen adjust base on the sub to or do you have to have an independent remote?